(800) 853-2651
SHOP NOW

Search results

  1. D

    MF 180, early model question

    I am working on a deal with a guy to trade a PTO generator that I have on his MF 180 tractor, I believe it to be a 1966 model, which is the first full production year. Do you have any concerns about this vintage 180, being very early model? Anything to look for? I think I have a good idea of...
  2. S

    Ford 861 powersteering

    Thanks for all your input! I tracked down the leak over the last couple of weeks and repaired the fitting for the output line from the pump and that stopped the leak. I am however still getting a leak from around the top of the actuator. It only happens when I turn the wheel...could it be a...
  3. S

    Ford 861 powersteering

    Thanks for feedback! I went out first thing this morning and pulled off the cap and it does look a bit low. I didn't see a fill line in the reservoir how much should I put in? I also noticed what is in there is milky so I'll run some fresh fluid through until it run clear and then I'll top it...
  4. S

    Ford 861 powersteering

    I recently purchased a Ford 861 that had factory installed power steering which works GREAT, but their is small leak somewhere around the steering column actuator. I haven't tracked down the leak and not too concerned about it yet, but I do think it needs some fluid. I was mowing last week...
  5. S

    Replacement cylinder for Ford 703 loader

    I cracked the head on one of my bucket tilt cylinders and it looks like the replacement head is nearly $300 and for that price I can probably buy two new dual action cylinders. I would like to know if anyone has already replaced their cylinders with new ones and if so...can you recommend a...
  6. S

    Ford 703 loader with cracked cylinder head

    Hello everyone, I was moving some dirt yesterday and in the process cracked the very tip of one of the hydraulic cylinder on the bucket tilt. I can't seem to find any information about these cylinders online and I don't believe that I have to replace the entire cylinder because the head screws...
  7. S

    Should I buy this '59 871?

    Hello All - This is the first of what I am sure will be many posts to come in the future. I am in the market for my first tractor and have decided that I would like a late '50s or early '60s ford tractor. I have been keenly watching classifieds for the past couple of months and came across a...
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top