Search results

  1. C

    John Deere 870 Dual Stage Clutch

    Good morning, I'm looking for the flywheel bolt torque. Dual Stage clutch. TIA
  2. C

    brake fluid question

    HI, I have a 40E construction tractor and need to know what type of brake fluid it takes. Does anyone have a manual to look this up and post the answer? TIA
  3. C

    Model ID

    Autolite 386. 388s are installed for now.
  4. C

    Model ID

    I thought the same until I purchased a tune up kit for a screw mounted dist. cap. The spark plug threads were too big.
  5. C

    Model ID

    Pics
  6. C

    Model ID

    Pic to help.
  7. C

    Model ID

    Some pics to help.
  8. C

    Model ID

    will do asap. it does have a 4cyl gas.
  9. C

    Model ID

    Hi, 4 cyl. gas.
  10. C

    Model ID

    Thanks, I'll post some pics asap.
  11. C

    Model ID

    Hi, Looking to order parts for this tractor. The dash has been replaced, no model/sn plate. Anything I can look for to identify what model it is? Has a 200 loader and a gas engine. Also has the right foot pedal directional pedal. Says acc on it (throttle).
  12. C

    64 Ford 4000 4cyl. coil type

    Thanks, that's what I thought. I remember 12 volts at the distributor even though I installed a napa coil IC14sB. Shouldn't the voltage be lower at the dist?
  13. C

    64 Ford 4000 4cyl. coil type

    Hi, looking to make sure I installed the proper coil on this tractor. I've read that when a 12v conversion is done, the 6v coil isn't replaced for easier starts. This tractor has a 12v conversion and I can't find the old coil at the moment to confirm what I removed. Can anyone verify this? I'll...
  14. C

    Ford 4000 year and engine size?

    Hi, can anyone help me identify my year and engine size? I know it's a 4000 with a 4 cyl gas engine. I read something about an 801 series tractor. That newer 4000s came with a 3 cyl? Thank you in advance. Numbers are: 57426 & 411055
  15. C

    1962 MF 202 lift pump filter

    Hi fellow tractor enthusiasts, I"m attempting to replace the hyd. lift pump filter in the rear end of 202 with a 6 speed transmission. I can feel it through the right side cover where the dipstick goes. It's mounted more to the left side near the cover. Question: can I replace it by removing...
  16. C

    1962 MF 202 lift pump filter

    Hi fellow tractor enthusiasts, I"m attempting to replace the hyd. lift pump filter in the rear end of 202 with a 6 speed transmission. I can feel it through the right side cover where the dipstick goes. Question: can I replace it by removing the cover on the left with a pto lever attached...
  17. C

    1964 Ford 4000 idle problem

    Hi, I changed the points/condenser. All 4 spark plug weren't firing and were replaced, as well. What could cause all 4 plugs to go bad? It appears that the points now have excessive blue arcing across the points. The electrical system has been changed over to a 12 volt system. I'll check later...
  18. C

    1964 Ford 4000 idle problem

    Hi, I have a 4000 with a 4 cyl. gas engine that won't go to high idle. It cuts out at about 600 rpms. I did install a carb kit after two days of soaking it. Timing is at 4 degrees at 425 rpms. Carb is receiving fuel to the float chamber. It does idle well at 425 rpms, just won't increase. I have...
  19. C

    ford tractor ID

    Hi, I could use an ID ASAP on a yellow tractor with a 525 loader. Numbers/letters appear to be: DU112K 6D2 C503281. Sorry for so many posts, I need to find out quickly. Thanks.
  20. C

    Ford tractor model?

    Hi Joe, sure it's a U, not a D from my previous response. I was able to run a flashlight beam across the face of the numbers making it very clear to me. Worn, but clear.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top