(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. J

    18.4 X 34 Tires Rims

    This may not be the right place for this question, but I’m wanting to change the 16.9-30 tires/wheels on my IH 560 standard to 18.4-34. Any one have a good source for tires and upgraded wheels? Thank you
  2. J

    59 IH 560 STD. Upgrading Hydraulic pump to add Power Steering assist

    Just a follow up. The power assist is working. Finally got the pressure to check out and is easier to steer. Thank you all for the advice.
  3. J

    59 IH 560 STD. Upgrading Hydraulic pump to add Power Steering assist

    Good evening everyone, I’ve attached photos of the renewed power steering assist I just got installed on the 560. Just so you know, the pump I installed is the “long” pump that has the secondary pump in it for the steering. I did use the original plate that was on the tractor originally with...
  4. J

    59 IH 560 STD. Upgrading Hydraulic pump to add Power Steering assist

    Hi all, I’ve got a 59 IH 560 Diesel STD. I’m adding an original hydraulic power steering assist cylinder. I have to change the hydraulic pump since what’s originally installed does not have the extra pump to push oil out to the power steering. My questions are: should I pull the drive gear off...
  5. J

    International 560 Std. Diesel hydraulic pump change

    Hi all, I’ve got a 59 IH 560 Diesel STD. I’m adding an original hydraulic power steering assist cylinder. I have to change the hydraulic pump since what’s originally installed does not have the extra pump to push oil out to the power steering. My questions are: should I pull the drive gear...
  6. J

    Farmall B hard starting

    Thank you Old and everyone else that responded. I will go back and re-time it again. Looking forward to reporting back good news.
  7. J

    Farmall B hard starting

    Thank you all for the comments. I do recall having an issue getting the mag to snap when I was setting the timing after the rebuild. Just to verify what you are all are saying, if the advance is not correct, it would cause the engine to barely roll over when trying to start? Just to clarify...
  8. J

    IH 1 bottom plow parts needed

    Thank you for the info.
  9. J

    IH 1 bottom plow parts needed

    Thank you for the info
  10. J

    IH 1 bottom plow parts needed

    Good evening, I ve got what I believe is a B192 1 bottom plow for my Farmall B. However, I do not have any of the connecting assembly. Anyone on this forum have these parts forsale or know where I might find them? Thank you This post was edited by JD70/B on 05/31/2023 at 08:15 pm.
  11. J

    Installing bearing cups and steel balls into IH 560 manu

    Steve, Thank you for the common sense reply. Your suggestion should work perfectly. Really appreciate the feedback.
  12. J

    Installing bearing cups and steel balls into IH 560 manu

    Good afternoon, Looking for feedback from anyone who has experience refurbing a steering column on an IH standard 560 or other model using manual steering. The parts book calls for a bearing cup and 14 steel balls for each cup at both ends of the worm gear. Besides the retaining rings...
  13. J

    John Deere 70 Power-Trol repair

    Thank you for the reply and advice.
  14. J

    John Deere 70 Power-Trol repair

    Thank you for the info Jim. Ill certainly go this route. Appreciate your assistance on this topic. Robert
  15. J

    John Deere 70 Power-Trol repair

    Hello all, Im going to be replacing the rubber o-rings in the two remote ports since they are leaking (2 per remote). Per my service manual I see no good instruction on how to replace them. The only advice it gives is to not lose the throttle valve and spring when taking the Power-Trol...
  16. J

    IH 560 Diesel Coolant question

    Thank you Rustred. I figured that was a by-pass. I cracked that open for a moment and of course there was coolant coming out. Should the petcock hole be blocked to let coolant pass into the block once it is opened or just let what ever air and coolant come out until it has reached the correct...
  17. J

    IH 560 Diesel Coolant question

    Thank you for your reply
  18. J

    IH 560 Diesel Coolant question

    Thank you
  19. J

    560d high rpm miss

    This message is a reply to an archived post by pete 23 on December 29, 2013 at 16:15:59. The original subject was Re: 560d high rpm miss. Hi Pete, My 560 is smooth at idle then pops and is rough when throttling up. Not much smoke at idle then starts blowing white smoke. Sounds like another...
  20. J

    Valspar 4432-01 IH Red

    <video width=90% src=https://www.yesterdaystractors.com/cvvideos/cvvideo99706.mov controls>http://forums.yesterdaystractors.com/cvvideos/cvvideo99706.mov</video>
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top