(800) 853-2651
SHOP NOW

Search results

  1. H

    How can you get to the instrument panel of a 600 ford ?

    Does anyone have a diagram on what bolts or screws to take out?
  2. H

    How can you get to the instrument panel of a 600 ford ?

    How hard is it to pull the hood off?
  3. H

    How can you get to the instrument panel of a 600 ford ?

    Can you have enough room to change out the gauges ?
  4. H

    How can you get to the instrument panel of a 600 ford ?

    How do you get to the instrument panel of a 600 ford tractor? do you take off the hood or the panel by the steering wheel?
  5. H

    Tachometer Proofmeter Ford 600

    I took off the cable there are no wires sticking out, just cover cap going to the bottom of the tractor, Can you take off the instrument cover of my 600 tractor. Not much room to work on. Having trouble with unscrewing from the top of the Tachometer. I have big hands. Thanks for your help !
  6. H

    Tachometer Proofmeter Ford 600

    were do you start ?
  7. H

    Tachometer Proofmeter Ford 600

    Tachometer Proof meter 600 Ford how do I repair one ?
  8. H

    1956 600 Ford Jumping Time

    I have a 600 ford tractor. I have put in new pugs, coil, electronic ignition rebuild the carburetor . It starts fine and run good at idle speed and midpoint but misses at wide-open or when it has a load. I have reset the distributor and it run fine for little while the goes back to the same...
  9. H

    600 ford

    Recently had a firing problem and the 600 wouldn't start ( got that fixed found out it was out of time). It runs fine with the haft throttle but it misses at full throttle. I have noticed oil coming out the air filter at the bottom. Or do you think it could the carburetor or a firing problem or...
  10. H

    600 ford

    Thanks to everyone who tried to help!
  11. H

    Woods Tiller-600 ford

    I have a slip cutch on my ford. With the PTO is really short. I have to have the lift up and put in the shaft when the lift is up and put the lift down to hook into. It takes two people to hook up. I think with the arm extension in would put the tiller back father and would be easier with a new...
  12. H

    Woods Tiller-600 ford

    I have a 5ft woods tiller. When I hook up the PTO shaft it really short and comes out when I lift up the lift. Is there any place I can find an arm extension so the PTO won't come out when I used the lift.
  13. H

    600 ford

    Thanks to everyone for the information ! finally got my tractor going. My neighbor came over and he is a good mechanic, For some reason, the firing order was wrong on the plugs. He took out the first plug and put his finger to feel the position of the piston and adjusted the distributor and it...
  14. H

    600 ford

    I replaced the EI still no start. I have a white spark. So are you saying to replace the starter switch?
  15. H

    600 ford

    What does Measured spark mean?
  16. H

    600 ford

    Did you still have spark? When I put the park pug analyzer on it is a white spark. Should it be blue?
  17. H

    600 ford

    NO
  18. H

    600 ford

    Do you think the timing could be out sink? Could this be the reason for not starting?
  19. H

    600 ford

    Would you try taking the distributor out before putting a tablespoon of oil in plug hole? How hard is it to take out the distributor out?
  20. H

    600 ford

    I have put a new coil, plugs and ordered a new electron ignition. Could leaving the key on causes your electron ignition to go bad? But if the electron ignition did n't work there wouldn't be spark right?
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top