(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. C

    Starter gear gets stuck in flywheel and won't start 1951 far

    Anyone ever experience a starter gear getting stuck in flywheel teeth every once and awhile on a 1951 farmall c and therefore won't crank? I have to loosen starter up and retighten then it works again like normall. Anyone know the fix or any suggestions? Starter motor was recently rebuilt and...
  2. C

    coolant leak

    I have received very good information on my coolant leak on 1951 farmall c, I just rebuilt engine, however I have seen where I have been told to retorque head nuts again after you let it runs and heat up and could take several times before they won't turn anymore at spec. I just forgot to ask do...
  3. C

    1951 farmall c governor issues

    I have a 1951 farmall c, I just installed engine, got it running and noticed it won't go full throttle. the lever for the throttle won't go forward far enough for full throttle and see no adjustment at governor. I noticed about 1" of play at governor where the throttle rod would hook to governor...
  4. C

    Installing cylinder sleeves on 1951 farmall c

    I appreciate your help thank you so much! Is this 0.001-0.004 spec. In a book some where? If so how can i get it? This could help me w/ other questions i may run into.
  5. C

    Installing cylinder sleeves on 1951 farmall c

    I please need advice! Long story short took my engine block and head to machine shop got rebuilt. Noticed sleeves stick slightly up higher than block deck surface. Asked machine shop over phone about it they said install head w/o gasket tighten evenly very slowly to spec. To draw them down all...
  6. C

    how to replace guide sleeve clutch release

    I am rebuilding 1951 farmall c engine, while I have engine out I am wanting to replace all clutch items I can. I can't figure out how to replace the clutch release sleeve guide (bushing). Any help would be greatly appreciated! It's #13 picture on page 114 in my parts book.
  7. C

    how to replace bearings on the tines on a 1980 master til...

    I was wondering how to replace the bearings for the tines on a 1980 master till by parmi made in lynn, Indiana. Does anyone know where I could get parts?
  8. C

    How do i remove clutch release sleeve guide bushing

    I am in need of suggestions on how to remove clutch release sleeve guide bushing in 1951 farmall c. Any suggestions would be greatly appreciated.
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top