-
U
861 spit and sputter
Thank you for the response! I will definitely try this and post my results when I get back out there. -
U
861 spit and sputter
I run a 5' bushhog and the previous property owner let our pasture grow up before we moved in. I had a friend come and cut it with his Kabota before I was able to get my 861 and bushhog. However he was not able to get behind the fence due to time constraints. So I got out there once I got my... -
U
861 Hydraulics
Yes! I know just the video to help me with that. Thank you for the help! -
U
861 Hydraulics
I currently have to have my hydraulics lever all the way to the top to be able to get the front of my bushhog off the ground. While it holds it there it will very slowly fall and then bump back up over and over again. Any ideas as to what is going on? I would rather not have to rebuild or... -
U
861 PTO issues
Wow! Thank you for the heads up! I will definitely do that before I continue using it. Any recommendations for what trans/hyd fluid and motor oil to use? -
U
861 PTO issues
So when I removed the PTO shaft I had about a gallon of brownish/creamish colored oil fall out. Is that normal? -
U
861 PTO issues
Honestly, all I can find is the "conversion assembly" so I bought a Conversion PTO Assembly (1-3/8") from STP that fits the 861. I originally took mine out to see if I needed to re-seat the bearing and seal as I've heard that can cause this. But found that my bearing and PTO housing is all beat up. -
U
861 PTO issues
I was having problems with my PTO popping out of gear while brush hogging. So when I pulled the PTO shaft out I found that it's pretty beat up. Can someone point me in the right direction to find a new PTO shaft? I'm just going to replace the whole thing. I found this one from the sites store... -
U
Issues with 3pt hitch lift
I am having issues with the lift on my '62 801. I have to have the leaver all the way up to raise the lift at all and even then after riding with a 5ft cutter it will slowly fall to where it's just dragging the cutter. Any pointers that can help me get my tractor in proper working order? -
U
Detent springs and plungers
Please excuse my ignorance, I am very new to the tractor life. I am pretty mechanically inclined though and was going to replace myself if I could find them. -
U
Detent springs and plungers
I have been looking all over and cannot find anywhere I can buy some detent springs and plungers for my '62 801 5 speed. Can someone point me in the right direction?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy