(800) 853-2651
SHOP NOW

Search results

  1. S

    1971 Ford 4500

    I did not see a pin. are you talking about a key? That slides into a cut out area on a shaft? I will def, check that out, I just changed both fuel filters, and they were really bad, I also changed a air filter I believe, it was coming off the side of the motor, And there was a lot of...
  2. S

    1971 Ford 4500

    Need some advice, I had fuel return pump rebuilt, I installed it, Bleed all the lines, The tractor cranked right up, Ran real rough though, I guess it ran for about 2 to 3 minutes and just died. I am getting fuel to the lines, But only when I am trying to crank it. Its not building up...
  3. S

    Fuel Pump

    OK Let me run through everything I have done, a recap, Got all the air out of the lines and was getting fuel, Tractor cranked right up, but was running rough, I let it run for maybe 2 minutes and it just died, then I was getting no fuel any were except the line coming out of the filter to the...
  4. S

    Fuel Pump

    I have not changed the fuel filter as of yet. I will get back with yall later today, I am going to start from the tank and move my way through the lines and see were its stopped up, I was just afraid I done some wrong installing the fuel pump.
  5. S

    Fuel Pump

    Had my fuel pump rebuilt, 1971 Ford 4500 industrial tractor. got it put on, bleed all the air out of the lines, everything was getting fuel to it, cranked and ran, but it was running rough, after a couple of minutes the motor died, now its not getting any fuel past the filter. My 1st thought...
  6. S

    Rear end

    I have a 1972 Ford 4500. Was putting new fluid in the rear end, Took the level plug out, started pouring the fluid in and the fluid started coming out of were the clutch arm goes into the rear end! Not sure what to do at this point, motor runs good, backhoe works good, Need some advice.
  7. S

    fuel pump

    It is the very bottom bolt that is facing towards the camera.
  8. S

    fuel pump

    Yea sorry, It is diesel.
  9. S

    fuel pump

    I am having a issue with fuel leaking out of the bolts on the bottom and sides of what I think is the fuel pump. My question is can i just take these bolts out and put O rings, or silicone? Need some good advice on how to treat this. I am trying to post a picture, but having difficulty doing...
  10. S

    4500 Ford clutch

    Update, Drained the transmission fluid, Had a lot of water in it, very little fluid, After a little playing around with it, the clutch seems to be working, Which is a relief, Didn't really want to put a bunch of money into the tractor.
  11. S

    4500 Ford clutch

    Hi everyone, I am having a problem getting my 74 4500 ford to go in gear, What I have read was its probably the clutch sticking. So I cranked it while it was in gear, and it drove, But it didn't fix the problem. Looking to you guys for any advice. Pretty sure the transmission is fine. Thanks
  12. S

    Foam in the tires

    Let me know how it turns out, I just decided to buy new tires, My thinking was spend the money to install the tubes and it only last a short time, and still have to buy new tires, just bite the bullet and do it right the first time.
  13. S

    Foam in the tires

    Alright Steve. Buddy I sure do thank you for your advice. I will let you know the outcome. Again Thanks!
  14. S

    Foam in the tires

    Alright, thats what I will do, thank ya'll!
  15. S

    Foam in the tires

    What about just trying the tubes? I wasn't sure how they'd hold up. The inside of the tires are good, just the bead is pretty boogered up, and i am having the wheels sandblasted,
  16. S

    Foam in the tires

    Hi everyone, My tires are 18.4-24 on my 72 ford 4500 tractor. The tires are old, I am having the rims sand blasted, the bead on the tires are no good, my question is should I try tubes, or foam fill them. And if I do use tubes any suggestions on prep work. And I am having trouble finding...
  17. S

    Backhoe controls

    I bought a older model 4500 ford backhoe, and the backhoe controls are broken, looks like they are made out of that old pot steel, I am having a hard time finding any replacements for them, Does anyone here know were i can find these?
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top