Search results

  1. A

    HELP - 6x4 Backfiring and No Start

    I was able to remove the flywheel with a harmonic puller. To my surprise the woodriff key is actually a part of the crank and not seperate? I cleaned everything up and took the opp. to replace the plugs and again re-seal the carb with new gaskets and gasket sealer. It fired up! I have no idea...
  2. A

    HELP - 6x4 Backfiring and No Start

    I was able to remove the flywheel with a harmonic puller. To my surprise the woodriff key is actually a part of the crank and not seperate? I cleaned everything up and took the opp. to replace the plugs and again re-seal the carb with new gaskets and gasket sealer. It fired up! I have no idea...
  3. A

    HELP - 6x4 Backfiring and No Start

    I went to oreilys and rented two (2) jaw pullers, however the 1st one (5-ton) was too small for the flywheel, and the 2nd one (7-ton), the metal was too think to fit behind the flywheel and the block. Anyone have a trick to get the flywheel off without using a hammer and pry bar?
  4. A

    HELP - 6x4 Backfiring and No Start

    I rented (2) two jaw pullers, however the 1st one (5 ton) was too small, and the 2nd one (7 ton) was too think to fit behind the flywheel and the block. Anyone have a trick to get the flywheel off without using a hammer and pry bar?
  5. A

    HELP - 6x4 Backfiring and No Start

    Thank you T.R.K. 1. If the cam gear is the issue, would the starter still operate the valves and have movement when starting is applied? Both sets of valves, rockers and push rods seem to operate fine with using the starter. 2. For the Spark Controller, do you mean the CDI or Ignitor...
  6. A

    HELP - 6x4 Backfiring and No Start

    I am starting to think the timing is off as well. However I can believe the cam gear has any problems as the valves are operating as intended. Yes, I rotated to TDC 2x and set gaps on valves each time. What else could be throwing the timing off? I checked TDC on the flywheel and confirmed...
  7. A

    HELP - 6x4 Backfiring and No Start

    I purchased a 1998 JD 6x4 with Kawasaki FD620D Liquid Cooled engine that will not start and only backfires through the carb when starting attempt. I have completed the following: 1. Compression tests show 175/180 2. Flywheel rotated to TDC on each cylinder and valves adjusted to 0.010 2a. I...
  8. A

    HELP - 6x4 Backfiring and No Start

    I purchased a 1998 JD 6x4 with Kawasaki FD620D Liquid Cooled engine that will not start and only backfires through the carb when starting attempt. I have completed the following: 1. Compression tests show 175/180 2. Flywheel rotated to TDC on each cylinder and valves adjusted to 0.010 2a. I...

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top