Search results

  1. B

    JD 5020 3 Pnt wont lift

    As per my previous posts I'm having some issues with the 5020 after she sat for a few years. I've just bled the power steering and that's now working as it should which is great. I've now noticed the 3 pnt wont raise for some reason, worked fine when she was stored away a few years ago. So have...
  2. B

    JD 5020 Steering

    Just bled the system and she is up and running.
  3. B

    JD 5020 Steering

    So tractor has sat for a few years and when I tried to drive her out the shed today she wont steer to the right. Turns just a very little then actual operator steering wheel just hits a wall and wont turn any further. Still turns to the left. Right cylinder seems to have a leaking seal so could...
  4. B

    John Deere 5020 electrical gremlins

    Well thank you gentlemen for all your previous advice on my shorting issue. I've disconnected the heavier brown wire from the 24v generator and that has stopped the shorting when I try to connect up the batteries. I've now managed to start her up which she did easily after sitting for a good...
  5. B

    John Deere 5020

    I understand your logic. I just shorted out each battery to the frame but nothing showed up. As soon as I try to link the batteries I get an arch, in actual fact it would easily melt the battery polls. Could there be an issue with the starter solenoid in that its drawing power to starter? Any...
  6. B

    John Deere 5020

    So I haven't had the 5020 out in 14 years. Tried fitting batteries today 2 12v in series but when I touch the linking cable they just flash. What am I doing wrong? Am I correct in saying they are 24v (alternator stamped 24v) and the their is no earth (ground) in the syatem. Any thoughts welcome.
  7. B

    Head Gaskets

    Well thanks for the earlier advice regarding fuel bleeding on the 900, she is now up and running again. Next question, are Case 500 head gaskets readily available and are the expensive? Alternatively has anyone ever re-used head gaskets or had some made? I've re-used head gaskets several time on...
  8. B

    Case 500 head gaskets

    Well thanks for the earlier advice regarding fuel bleeding on the 900, she is now up and running again. Next question, are Case 500 head gaskets readily available and are the expensive? Alternatively has anyone ever re-used head gaskets or had some made? I've re-used head gaskets several time on...
  9. B

    Case 900 diesel bleeding

    So I haven't had the 900 out in a while and I think air has got into the fuel system, I did get her started although the engine was surging a lot then after a few minutes running she slowly died and stopped. She has a Bosch PES external drive pump with attached transfer pump but no hand primer...
  10. B

    Case 900 diesel bleeding

    So I haven't had the 900 out in a while and I think air has got into the fuel system, I did get her started although the engine was surging a lot then after a few minutes running she slowly died and stopped. She has a Bosch PES external drive pump with attached transfer pump but no hand...
  11. B

    Ford 4000 replacing rear axle seal

    Yes mine would be classed a row crop tractor not exactly the same as you guys but similar. Ill check out the bolt heads tomorrow. Yes I've got a 1.5m bar on it.
  12. B

    Ford 4000 replacing rear axle seal

    So ive just replaced the right axle seal and wheel bearing with good success. I now doing the left side axle (as seen while seated on tractor) problem though is that I cannot seem to manage to slacken the half shaft cap screw so end result I cannot remove it to replace the seal. Having put a...
  13. B

    Ford 4000 Rear axle seal replacement

    So ive just replaced the right axle seal and wheel bearing with good success. I now doing the left side axle (as seen while seated on tractor) problem though is that I cannot seem to manage to slacken the half shaft cap screw so end result I cannot remove it to replace the seal. Having put a...
  14. B

    Massey 1155 cab roof

    Your a star, many thanks.
  15. B

    Massey 1155 cab roof

    Can anyone say how easy it is to remove the white roof section on a MF 1155 cab? Looks like it?s held along the sides with screws so removing them might allow the top to be lifted off. Any advice welcome.
  16. B

    John Deere 820 pump rack.

    Okay guys that's the 820 running, stuck rack. I lubricated and worked it back and forth a number of time to ensure it was operating as it should. Before I bought the tractor it sat outside unused in Canada for several years, I guess condensation had formed with the temperature changes. Thanks...
  17. B

    John Deere 820 pump rack.

    From my previous post it seems as if the rack on the fuel injection pump could be stuck. Can anyone explain how to get at the pump. A workshop diagram would be helpful if anyone can help. IT shop manual doesn't show much.
  18. B

    John Deere 820 wont start

    Don't suppose anyone got any pictures, Ive only got an IT shop service booklet which doesn't show much.
  19. B

    John Deere 820 wont start

    John Deere 820 black dash two cylinder. When I put it away earlier in the year diesel engine started and ran fine. Tried starting today and although she turns over fine it wont start. Any thoughts on what might be the problem? Did wonder if anything could be stuck with it sitting for several months.
  20. B

    Massey 1155 missing Hood panels

    Not sure who I?m talking to but we must have talked before as you know I?ve a 2805? I?m considering selling the 1155 and 2805 in the next few months. I?m not sure what you mean by page two etc. Can you maybe clarify? Bill

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top