(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. F

    Farmal H LP fuel system parts

    I worked on propane conversion and repairs for some time I have not worked on tractors. I have worked on trucks cars fork lifts ect. The first thing to check on a lp sys is the water leval in rad most l p systems need water to circulate through the vaporizer this changes the propane from a...
  2. F

    424 gas tractor missing under a pull

    I think it has a fuel pump like my 276 ? it gave me a problem when under load {fuel starving] check fuel presure at pump . I am not sure what it should be. dealer or manual can tell you . hope this helps D F .
  3. F

    decals

    need decal set 1968 international 276 not avail at dealer thanks D F.
  4. F

    276 hyd leak

    my 276 has a oil leak at hyd valve ? front of tranny is there a O ring on the lever shaft if so is it hard to replace thanks for any help.
  5. F

    ford 4000 charging

    ford 4000 not charging I had generator checked OK we installed new regulator still not charging we polorized regulator no charge . where to conect meter to generator only to recheck on tractor any help much app thanks this tractor is 6 volt positive ground
  6. F

    IH 276 manual

    no manuals listed for 276 I H at binder
  7. F

    IH 276 manual

    I need help with 276 international . i would like to find a repair or even a user manual , would any one know what trans oil . hyd oil. rear end oil ect and app how much i need .i am going to take apart to paint soon and would like to change all fluids on reassembley.. thanks d f
  8. F

    276 int

    how much hyd .diff oil in a international 276 ? also what oil to use ? is there a filter? i need munual. also tack drive gear [plastic] in distributer
  9. F

    dist . tack drive 276

    I need a dist. r p m drive gear plastic for a internationan 276 gas a414 has the same part number no longer available at dealer. ANY ONE HAVE A GOOD USED OR NEW ONE? thanks D F
  10. F

    manual

    thanks again i found them. i was wondering if a b276 and a276 are the same what does the B stand for mine is a 276 ser. number is 2186 like to know if the tractors are the same before ordering. THANKS A LOT D F
  11. F

    manual

    thanks for reply glennster I checked there for a b276 also 276 and got message that no match for these models mayby i am not doing it right? thanks D F
  12. F

    manual

    where can i get a manual for a 276 international ? i think it is a u k model it has positive ground .it is a gas model app 1968 year .there is not much listed for this tractor i like the C D manual. any info such as oil . hyd filter where located ect would be great thinks for now..
  13. F

    oil presure

    my 275 has a oil presure light. I am adding a gauge . What ssould presure be? How high of a gauge should I use> thanks for now D F
  14. F

    steering on 276

    is there any problems with steering box on international 276 mine is heavy also it feels rough when turning .are steering boxes the same on other tractors i suspect i may have to change or repair this one ps its full of oil any help would be appreciated D F
  15. F

    stearing box 276

    just bought international 2 7 6 gas it has a rough stearing box any ideas as to the problem?What other model will fit ? this IS NOT power stearing Thanks DEAN
  16. F

    massy ferg 1650

    Sorry to bother you again Roger. Is the blower you use on the 1650 a 1 or 2 stage also what rotation is the tractor pto? thanks deane ps I did not buy tractor yet .waiting to see what i can come up with for attachments.
  17. F

    massy ferg 1650

    thanks roger does your blower have shaft for pto and does it push into back of tractor?are thease p t o shafts available ?does any other tractors use this same shaft, blower , tiller ect and does this tractor have enough power? thanks deane
  18. F

    massy ferg 1650

    this mower is a 1984 with 3 point hitch and pto will this run a snow blower ? can one still be got?the pto at tractor is femail what shaft fits is this a good tractor krowler 16 horse model of tractor is 1650 thanks
  19. F

    M F 135

    thinking of buying m f 135 1973 model diesel what should I look for ? Are there any problems with these tractors ? thanks
  20. F

    shaft bearing

    i am replacing main input shaft pilot bearing on farmall H tractor i have it apart with pulley accembley off should the bearing go into the gear easy ?are they hard to line up easy?any tips out there ? I woule like to know if ttis is easy I am waiting for bearing [ordered] thanks
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top