1520 John Deere Injector Pump

dleefarms

Member
I tried posting this on the John Deere board but to my dismay no one bothered to reply so I'm going to try this board before giving up on this website altogether.

I am in need of removing the injector pump from my 1520 for repairs. Is there anything special that needs to be done to keep it in time as the shop manual states? Also is a difficult R&R? Any and all advice will be greatly appreciated. Thanks in advance.
 

I didn't reply to your other thread because I thought one of the more knowledgeable forum members on inj pumps would reply.

IIRC you need to put engine #1 piston on TDC compression stroke. Remove access cover on frt of the timing cover. If engine serial # is below 117499 you need to remove 3 bolts & if SN is above remove nut/washer. Be careful so as to not drop any hardware inside frt cover.
 
I did my 1520 two years ago, easy peasy do get new injectors also. My pump was a JDB there is a plate on front of engine take that off and there is a bolt under it. Take off lines and three bolts and pull the pump and shaft out together. It has a key way so timing is not a problem have them install umbrella seals so when you get it back all you have to do is bolt it up.
 
Here are some pics of the pump.
cvphoto57308.jpg


cvphoto57309.jpg
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top