pea_grower
Member
I've blown out the bearing on the sickle head on a Gleaner floating head for a F2 Gleaner. What came out was a double roller, but looks like the parts book may require 2 single roller bearings. And it appears to only have had one snap ring.
There is not a grease zerk in the sickle head to grease the bearings. I guess there is a chance that its not the right sickle head for this header, and could have come off of something else.
If I see the correct bearing in the old book, the 2 bearings are 1307332-5 and require 2 snap rings.
Do you guys use a double rolling bearing, or 2 single rollers for this? And what do I need to do?
There is not a grease zerk in the sickle head to grease the bearings. I guess there is a chance that its not the right sickle head for this header, and could have come off of something else.
If I see the correct bearing in the old book, the 2 bearings are 1307332-5 and require 2 snap rings.
Do you guys use a double rolling bearing, or 2 single rollers for this? And what do I need to do?