Ford 4000 Spark Issues

Tyler F

New User
Hello,
I have a Ford 4000 SU that I recently installed an electronic ignition on. Now I only have spark to 2 cylinders. All of the spark plug wires were tested and are functioning properly. When I first started testing the spark I had no spark on cylinder 3. I removed the magnetic sleeve to ensure it was seated properly and reinstalled and then I had no spark on cylinder 1 rather than cylinder 3. Is it possible the electronic ignition is faulty or perhaps just the magnetic sleeve? I am at a loss for what to do other than put the points back in. The coil was updated as well and I have 12 volts to the coil.

Any recommendations would be appreciated.

Thank you
 
Is the shaft in the distributor possibly bent causing the gap between the moving magnets and the module at vary at different points in the rotation of the sleeve??

How close is the magnet sleeve to the module, try setting it as close as you can without the parts contacting each other in operation and see if that makes any difference.
 
Are you absolutely sure the pickup unit is mounted in
the distributor correctly and it is the right one for your
tractor by the manufacturers number? I thought this
same problem came up recently. I found a post that
mentions using the clockwise or counterclockwise
holes. See link, it also shows a couple test procedures.
Not sure if it applies to the brand of ignition you have.
Previous YT post
 
As with what wore out mentioned, how much does the distributor shaft move in/out, up/down, however you want to say it. I had one on a JD4010 LP burner, that the shaft was moving up and the pickup wasn't
reading the magnet on the ring. So check the endplay of the shaft and add a shim to take up the endplay or replace the distributor like I did.
 
Is the distributor cap mounted firmly on the base? When we
put electronic ignition on our 4000 SU the distributor cap
wobbled a bit, until I modified the original points dust cap to
clear the electronic pickup. The dust cap was needed in the
sandwich to get the distributor cap clamps tight.
 
Watch the spark at the coil. See if it is firing four times per distributor revolution.

If it is firing 4 times, the spark is getting lost between the distributor and the plug wires, as in the rotor not lining up with the cap terminals, or a bad/wet cap.

If the coil only fires one or 2 times per shaft revolution something is wrong with the magnet or the pick up unit.

Assuming it is a Pertronix system, give them a call, they will talk you through it.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top