hydraulic pump removal

Lee Cavanagh

New User
trying to get hydraulic pump off the front of a 1968 case 680 dielel backhoe, took the two bolts holding pump in place but the pump will not budge, anybody have any ideas how to do this.
 
Not familiar with the exact mounting on that machine but typically front mounted pumps are either driven off of a splined or keyed shaft attached to the crank through some type of flexible coupling or possibly directly off of the coupleling, again through a splined or keyed drive. I just ran into one on a 165 MF that was splined and the splines had worn and twisted locking the pump to the shaft. All I can tell you is that getting the two parts seperated was a nightmare. That said try soaking the joint in penetrant and let it set a few days or worst case scenerio break out the hot wrench. Sadly in situations like this there usually aren"t alot of good choices since there isn"t any real way to put mechaincal pullers, etc to pull the components apartso you wind up simply relying on brute force or a torch.
 
Just removed one from a gas powered Case of that era and it is splined and "should" slip off. I just unbolted the flex drive of the pulley because it was stuck at the splines.
 
They can get stuck something awful. I had to fight the pump on my Case 580CK and almost broke the pump before I got it off.

The Cessna aluminum pump housing can have a reaction with the cast-iron saddle it sits in and get stuck. Disimilar metals and moisture causes that. Also, the splined shaft from the pump can get stuck in the drive-parts.

If all was clean with no corrosion, it would slip out by hand once the bolts were out. Now, you have to force it.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top