Stan Coryell
Member
I replaced the original 48" Material Bucket on my Massey Ferguson 202 (100 Loader) with a 72" Kubota Bucket. No Issues.
I have a few small stumps and two dry wells to put in and the 48" seems like a good fit. The 48" Bucket needs a new cutting edge, sides, and a bottom. I'd like to put teeth on it with weld-on shanks. I'd like to pick the shanks to match the cutting edge (3/8" plus or minus) and bottom (3/16" or plus) thickness to them.
Any suggestions on spacing or type? I'd prefer a knock-off that is available. Like JD, Kubota, etc.
I have a few small stumps and two dry wells to put in and the 48" seems like a good fit. The 48" Bucket needs a new cutting edge, sides, and a bottom. I'd like to put teeth on it with weld-on shanks. I'd like to pick the shanks to match the cutting edge (3/8" plus or minus) and bottom (3/16" or plus) thickness to them.
Any suggestions on spacing or type? I'd prefer a knock-off that is available. Like JD, Kubota, etc.
