Mark David
New User
Hi Folks, I just got a 1964 Ford 2000 Industrial tractor. It has the 4 cylinder gas engine and 4-speed transmission.
It has no PTO and no 3-point hitch - as delivered from the factory I'm told - apparently meant just as a loader/backhoe tractor - which is fine for me - I just need a loader that has more lift capacity than my little IH 1050 loader on a Cub LoBoy 185 (500 lbs max lift including the 150 lb bucket...).
It has a loader mounted on it (I believe a model 724) with an add-on high-volume hydraulic pump mounted on the front and powered by a coupler and shaft from the front of the engine - the hydraulic fluid reservoir for the loader is in the frame of the loader.
So, my question is this - Is there any reason that I should put hydraulic fluid, or any other fluid (gear lube to match the trans and diff) in the hydraulic reservoir under the seat that is supposed to be for the "factory"/built-in hydraulics that this tractor apparently has never had?
Or would it be better to just leave it empty?
It has the dip-stick on the left side, but it appears to be bone-dry in there like it has never been filled - which I suppose could make sense as long as any bearings for the shaft between the transmission and the rear differential housing are lubricated from the transmission and rear diff sides rather than depending upon there being hydraulic fluid in that reservoir in between.
But wanted to ask you folks who know way more about these tractors than I do.
I have read that some folks have taken to using "universal tractor fluid" in all three (trans, hydraulic reservoir, and rear diff) to avoid any problems with mixing of hydraulic fluid with the gear lube in the case that a seal between the different areas fails, but in the case of my tractor, if the hydraulic reservoir should have something in it, I would probably just go with the same gear lube as the trans and diff since there doesn't seem to be any "built-in" hydraulics on this tractor.
Thanks!
It has no PTO and no 3-point hitch - as delivered from the factory I'm told - apparently meant just as a loader/backhoe tractor - which is fine for me - I just need a loader that has more lift capacity than my little IH 1050 loader on a Cub LoBoy 185 (500 lbs max lift including the 150 lb bucket...).
It has a loader mounted on it (I believe a model 724) with an add-on high-volume hydraulic pump mounted on the front and powered by a coupler and shaft from the front of the engine - the hydraulic fluid reservoir for the loader is in the frame of the loader.
So, my question is this - Is there any reason that I should put hydraulic fluid, or any other fluid (gear lube to match the trans and diff) in the hydraulic reservoir under the seat that is supposed to be for the "factory"/built-in hydraulics that this tractor apparently has never had?
Or would it be better to just leave it empty?
It has the dip-stick on the left side, but it appears to be bone-dry in there like it has never been filled - which I suppose could make sense as long as any bearings for the shaft between the transmission and the rear differential housing are lubricated from the transmission and rear diff sides rather than depending upon there being hydraulic fluid in that reservoir in between.
But wanted to ask you folks who know way more about these tractors than I do.
I have read that some folks have taken to using "universal tractor fluid" in all three (trans, hydraulic reservoir, and rear diff) to avoid any problems with mixing of hydraulic fluid with the gear lube in the case that a seal between the different areas fails, but in the case of my tractor, if the hydraulic reservoir should have something in it, I would probably just go with the same gear lube as the trans and diff since there doesn't seem to be any "built-in" hydraulics on this tractor.
Thanks!