Stover hit and miss help

[Farmall m farmer]

I got it about a year and a half ago the only experience I have with this kind of engine is looking at them at shows what model is it what year was it built I got it to run but how much do I turn the mixer screw out I turned it out about 1/2 and it seemed like enough but I think the governor is set to low because it hits a couple times and then dies how do I set the governor and fuel screw I figured out how the choke works

 

[Farmall m farmer]

Here’s the pictures

 

[flembo]

Ask this question on the stationary engine forum. there is a lot knowledgeable folks there. It is way down near the bottom of the list of forums.

 

[greenmech]

I got it about a year and a half ago the only experience I have with this kind of engine is looking at them at shows what model is it what year was it built I got it to run but how much do I turn the mixer screw out I turned it out about 1/2 and it seemed like enough but I think the governor is set to low because it hits a couple times and then dies how do I set the governor and fuel screw I figured out how the choke works

I would turn it out more and if it smokes too much cut it back. Ron MN