6610 steering problems

Chrissub

Member
I have a Ford 6610 that the steering is tight. I have replaced the pump but still no change. It is hard to turn both directions. I’m thinking my steering motor is bad. Anyone had this problem? If so can I have mine rebuilt? Who can do it? Thanks
 
I have a Ford 6610 that the steering is tight. I have replaced the pump but still no change. It is hard to turn both directions. I’m thinking my steering motor is bad. Anyone had this problem? If so can I have mine rebuilt? Who can do it? Thanks
Have you checked the pump pressure. Are you sure you got the right replacement pump? I have never had to replace a steering motor. Resealed them, yes, top and bottom.
 
Have you checked the pump pressure. Are you sure you got the right replacement pump? I have never had to replace a steering motor. Resealed them, yes, top and bottom.
Tractor has a new pump, I checked the numbers and it checked out to be correct.
 
I have a Ford 6610 that the steering is tight. I have replaced the pump but still no change. It is hard to turn both directions. I’m thinking my steering motor is bad. Anyone had this problem? If so can I have mine rebuilt? Who can do it? Thanks
Get yourself a couple of farm jacks and jack up the front end. Then watch the rotation of the front tires as you turn the wheel. I recently bought a 1990's series tractor that the seller said only steered if the tractor was moving....had a loader. I wanted it for several reasons and bought it, delivered WITHOUT the loader. Got it home and "farm" jacked up the front end. The steering worked ok on one side but was deficient on reach in the opposite direction.

In checking the front spindles, the PO had no idea as to what to do with a grease gun. I put about one tube in one side and about a tube and a half in the other side working the steering back forth for a time. That did the trick. Surely there are some bearings in the lower spindle area that are damaged, but with removal of the loader and the application of adequate grease it steers like a dream.

One of my problems with USA designed or just sold, older tractors is their bracing for loaders. The equipment designers were derelict in their duties in their loader mounting designs. They almost totally blocked any access to the engine area and put massive weight on the front steering systems and I have totally rejected any US sold tractors with that STUPID designed loader support mechansim.

The current day, mostly oriental designed tractors, are smart enough to support the loader at mid tractor whereby when the loader is maxed out in the up position one can raise the hood and have total access to the engine area for whatever is needed........shame on you narrow minded designers!!!!!!!

If you have a problem with what I just said, look at the Case-IH I just purchased that was for sale with a loader, and the loader's mounting, and then look at the mounting for the loader/frame on my 2007 Branson 6530 or LS MT2-25 made in Korea design.....night and day....no brag, just fact, like it or leave it. You can look at Fords and find the same problems since I never had the many Fords I have owned over the years with a loader!!!!!
 
what kind of pressure should I have at full lock?
My book lists 1050psi for a 6610. Assuming that's correct AND assuming you bought the correct pump AND assuming they supplied you the correct pump that's your ballpark.... lol

Check the pressure coming out of the pump at full stall. Then check the pressure at the cylinder fittings at full stall. See if they match.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top