NH baler bale tie fixed

[old]

But it fought me tooth and nail to get it to work. Drove to Eldon MO and got a new NH switch and installed it. First try didn't work so switched 2 wires around and still. Still didn't work.didn't work. Went and looked at the manual tie set up and then back to the electric tie one. I noticed a wire had come loose at the 4 wire trailer plug some one put on it. Hooked that wire up and it worked just fine so tomorrow I'll bale hay I hope

 

[Jim.ME]

Glad to hear you got it working.

Sounds like that wire might have been the problem, not the switch. It didn't show up when troubleshooting, or did it get pulled loose during the switch change?

 

[old]

Glad to hear you got it working.

Sounds like that wire might have been the problem, not the switch. It didn't show up when troubleshooting, or did it get pulled loose during the switch change?

The switch disassembled is self so bad no matter what.. As for the wire not sure when it got pulled apart but sure did make a difference when I found it and hooked it up. While it appears by look a 4 wire set up the wires that where pulled loose make it appear to be a 2 wire motor not 4 wire like it looks like it is

 

[Absent Minded Farmer]

But it fought me tooth and nail to get it to work. Drove to Eldon MO and got a new NH switch and installed it. First try didn't work so switched 2 wires around and still. Still didn't work.didn't work. Went and looked at the manual tie set up and then back to the electric tie one. I noticed a wire had come loose at the 4 wire trailer plug some one put on it. Hooked that wire up and it worked just fine so tomorrow I'll bale hay I hope

Glad to hear it & good luck tomorrow!

Mike