Hello!
Here is my 1086 I did a couple years ago. As is with all of the customs I build, I make most of the parts I need, either with my 3D printer and Tinkercad, or I make a pattern and use resin.
This 1086 is an 1980's Ertl that I cut the cast engine out and replaced it with a resin copy I made.
The 3D parts list. - front/rear wheels, front axle, frame rails, three point hitch, steps, dual hubs, draw bar/PTO and lower grill. The rear tires, upper grill, front weights and engine are all resin. The ROPS roof and tail lights are from Dakota Toys.
The unfinished plow is an old 4 bottom Ertl pc. I extended , and the rest is either resin or metal.
I made the plow a couple of years before Ertl came out with their nice 5 bottom.
Here is my 1086 I did a couple years ago. As is with all of the customs I build, I make most of the parts I need, either with my 3D printer and Tinkercad, or I make a pattern and use resin.
This 1086 is an 1980's Ertl that I cut the cast engine out and replaced it with a resin copy I made.
The 3D parts list. - front/rear wheels, front axle, frame rails, three point hitch, steps, dual hubs, draw bar/PTO and lower grill. The rear tires, upper grill, front weights and engine are all resin. The ROPS roof and tail lights are from Dakota Toys.
The unfinished plow is an old 4 bottom Ertl pc. I extended , and the rest is either resin or metal.
I made the plow a couple of years before Ertl came out with their nice 5 bottom.
