More questions… hydraulic and transmission bottom plates… 63 4000 industrial 4 spd

So I’m servicing my tractor and want to get as much sludge out as possible. Planning on taking the cover off the transmission and figured I’d do what I could to clean the hydraulic compartment through the fill hole but I found these two plates under the tractor. Can I take these off without springs or valves or whatever falling out? Are they simply plates for better access to the compartments? The exploded views of the diagrams aren’t much help and the transmission bottom plate isn’t even called out. Thank you
 

Attachments

  • IMG_0292.jpeg
    IMG_0292.jpeg
    2.8 MB · Views: 0
  • IMG_0294.jpeg
    IMG_0294.jpeg
    3 MB · Views: 0
What shaun posted. I suggest that yes you can readily flush the transmission, using a "Hot Shot" air pressurized refillable can with fuel in it. Use the same can through the round access hole to the hydraulic chamber on the left. Your most rewarding clean out will be the differential because the drain is at an inch and a half higher level than the bottom. You will get a lot of mud and water out through the PTO shaft hole by using a tool you make up like a garden hoe.
 
The 4 bolt will get what is on it as that is a dry hole. The 5 bolt is almost impossible to get off will gain nothing, There are lots of other places sludge will collect that will require splitting.
Not sure I follow the 4 bolt comment. Are you saying that if I take it off, it doesn't provide access to the bottom of the transmission comparment? What is it for? Thank you
 
What shaun posted. I suggest that yes you can readily flush the transmission, using a "Hot Shot" air pressurized refillable can with fuel in it. Use the same can through the round access hole to the hydraulic chamber on the left. Your most rewarding clean out will be the differential because the drain is at an inch and a half higher level than the bottom. You will get a lot of mud and water out through the PTO shaft hole by using a tool you make up like a garden hoe.
Are you talking about something like this? https://www.harborfreight.com/32-oz-refillable-pressurized-sprayer-59544.html

Ok, I will clean the hydraulics out through the fill hole and the transmission with the cover off.

I already got a good look at the rear diff. I took out the pto shaft without draining the fluid first, heh. Glad I had my big pan under it cause that fluid came out like a raging waterfall. Lesson learned.
 
Not sure I follow the 4 bolt comment. Are you saying that if I take it off, it doesn't provide access to the bottom of the transmission comparment? What is it for? Thank you
It provides access to the bell housing area, which is a dry compartment where the flywheel and clutch reside. There should be a hole in that plate with a cotter pin installed loosely in the hole. The hole is to allow any fluids that leak from the rear of the engine or the front of the transmission into the bell housing to be able to drip out the bottom so that the clutch doesn't get contaminated. The cotter pin is there to rattle around in the hole when the tractor is running to keep the hole from getting clogged with dirt and mud.
 
Are you talking about something like this? https://www.harborfreight.com/32-oz-refillable-pressurized-sprayer-59544.html

Ok, I will clean the hydraulics out through the fill hole and the transmission with the cover off.

I already got a good look at the rear diff. I took out the pto shaft without draining the fluid first, heh. Glad I had my big pan under it cause that fluid came out like a raging waterfall. Lesson learned.
Yes, that is the can. I find it very useful. Did you clean out the water and mud from the differential? The transmission has no plate on the bottom. As I posted before you will do a lot better through the PTO lever hole than the fill hole.
 
Yes, that is the can. I find it very useful. Did you clean out the water and mud from the differential? The transmission has no plate on the bottom. As I posted before you will do a lot better through the PTO lever hole than the fill hole.
Ok, because I am dense as lead, the rear diff I will clean out through the rear hole where the PTO shaft comes out of, the hydraulic compartment remove the PTO lever plate on the left side under the seat, and the tranny I will remove the top cover to clean it out. Sound right?

I haven't cleaned out the rear diff yet. Been waiting to do it all at once, but I will be doing it soon since I just got the PTO shaft all put back together, finally.
 
I have a 1 gallon "garden/weed sprayer with a wand and hose that i fill with diesel fuel to clean out those cavities!
I do have an extra 1 gallon sprayer that I could use, but I also don't want to ruin the seals and gaskets. I guess if I use it for a short time and clean it out, it will be fine.
 
Ok, because I am dense as lead, the rear diff I will clean out through the rear hole where the PTO shaft comes out of, the hydraulic compartment remove the PTO lever plate on the left side under the seat, and the tranny I will remove the top cover to clean it out. Sound right?

I haven't cleaned out the rear diff yet. Been waiting to do it all at once, but I will be doing it soon since I just got the PTO shaft all put back together, finally.
You got it right now!
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top