generator issues

Ronalddean

New User
I have a 1960 John Deere 430 positive ground. I have had the generator tested and was told it was good. I have put a new regulator on and polarized it. The multi tester shows 6v (tractor off) 6v (tractor running). Ammeter gauge shows 0 but when I turn the headlights on the gauge goes into the negative. Any ideas??
 
The generator gets polarized, not the regulator.

What rpm was the engine running when you tested the voltage?

Ground the field terminal of the generator when the engine is running half to 3/4 throttle, and see if the voltage changes.

Is the regulator well grounded?

Did you check continuity of the charging system wires?
 
Did you check the voltage with a digital multimeter? Use an analog. Digitals do not work well on DC gens. Ground the field terminal and the amps should jump higher. Is it a three brush generator? Moving the third brush closer to the fixed brush should increase the output.
 
Did you check the voltage with a digital multimeter? Use an analog. Digitals do not work well on DC gens. Ground the field terminal and the amps should jump higher. Is it a three brush generator? Moving the third brush closer to the fixed brush should increase the output.
A 430 should not have a three-brush generator, it is a two brush with regulator.
 
The generator gets polarized, not the regulator.

What rpm was the engine running when you tested the voltage?

Ground the field terminal of the generator when the engine is running half to 3/4 throttle, and see if the voltage changes.

Is the regulator well grounded?

Did you check continuity of the charging system wires?
I just polarized the generator itself. Still getting the same readings. The Tach is broken, but I run the tractor at 3/4 throttle.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top