(800) 853-2651
SHOP NOW

Recent content by 11

Yesterday's Tractor Forums
  1. 1

    1200 getting ready for new engine

    How do you like your 1200 with the 504,Im hoping the 20hp extra will be a big difference, the old 451 was pretty tired so anything will be an improvement, im also getting the driveshaft brake and parts from a 1470.
  2. 1

    1200 getting ready for new engine

    Here is the 1200 getting ready for her new 1370 engine
  3. 1

    Case eagle statue

    Looking at a case eagle statue, like new condition, its concrete, anyone know how much it would weigh and what its worth, is it original or is it a reproduction? i have heard about both cast and concrete ones, any info would be greatly appreciated. Ben
  4. 1

    400 diesel

    Just bought a 730 diesel to replace the 400 that i use for mowing, now the 400 can get some work, rear main seal, injector pump and paint.
  5. 1

    Recent Purchase 730 diesel

    Just bought this 730 diesel, paint is horrible but runs great, will be getting paint this winter.
  6. 1

    Next winters project 830 Case O Matic

    My next winters project 830 Case O Matic
  7. 1

    1200 oil pan

    Could someone tell me if the oil pan on a 1200tk can be removed without lifting the engine or removing any steering parts, it looks like there is room but im not sure if it will clear the oil pump. Thanks Ben
  8. 1

    20.8x38 tires on 400 Case

    A while back i asked anyone if they had 18.4-38 or 20.8-38's on a 400. I finally took the 20.8 axle duals off my 1570 and put them on my 400. they look pretty big but with 10 or 11.00-16 it will sit level. Ben
  9. 1

    G900 rear wheel weights

    Looking for rear wheel weights for a 1969 G900 Minneapolis Moline tractor with 38" tires. Ben 519-818-8217
  10. 1

    18.4 or 20.8-38 on 400

    I am thinking that the 20.8's are to big, i will probably go with the 18.4's but i have real good 20.8's from the axle duals on my 1570 Ben
  11. 1

    18.4 or 20.8-38 on 400

    Has anyone seen or have a 400 with 18.4 or 20.8-38 tires, i have a real good set of 20.8s i am thinking of putting on, but i would also need bigger fronts, just wondering if anyone has any pictures of the 400s or early 730 or 830s...
  12. 1

    Combine Pictures

    Gary could you tell me the value of a 120 that is in great running condition and cut wheat last fall with brand new tires all around, also what engine did they use was it a DC engine or a 400 engine it was to dark in the back corner of the barn to tell Ben
  13. 1

    930 Injector pump problem

    Brad thats the right cap the rack and screw will stick out when measured from the front of the pump about 7/8 to 15/16 of an inch out. When you take the cap off with the throttle part way open the rack should come out about a 1/4 of an inch past the cap. When you push it back in it should pop...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top