(800) 853-2651
SHOP NOW

Recent content by 137 farm

Yesterday's Tractor Forums
  1. 1

    Case/international 485 Bosch VA pump removal

    Got it, thanks you all.
  2. 1

    Case/international 485 Bosch VA pump removal

    Can anyone explain to me why on my case international 485 removing the Bosch VA injection pump, why I cannot just remove the three bolts that hold the drive gear on the pump and then take the pump out to the backside. As of the injection shop says I have to leave the 3 bolts in place and remove...
  3. 1

    Teff hay

    The seed salesman told me I had to mow it about 4 to 6 inches tall, not as short as you mow most hay. Does anyone know if that is true and why it has to be mowed taller, will it kill it if mowed short?
  4. 1

    Hercules engine

    Wear are you/the engine located and does it have a clutch? Jason
  5. 1

    Hercules engine

    I am looking for a block for a Hercules model L engine, bore & stroke are 4.5 & 5.75, this was originally used in a truck from the mid-1920's. I would look at a complete engine to replace this one, a Continental Red Seal or large 4 cylinder Wisconsin engine should be an acceptable exchange...
  6. 1

    Difference in hay weight now vs when baled

    You shouldn't bale wet hay, it can self ignite, even round bales. My square bales never change wt from baling time thru the winter, they stay consistent, both grassy hay and alfalfa. Now pure clover tends to always dry out more in the barn and get lighter after 2-3 months.
  7. 1

    Over heating engine

    Steve and Markct or whoever: what would be a normal operating temperature? I would guess 180' as idea temperature, based on my diesel vehicles usually running that and never any hot. Those are good thoughts that I haven't checked, especially the sensor. I might have checked the temperature...
  8. 1

    Over heating engine

    Yes the radiator shop boiled the radiator clean. Fan blades are clean. Yes I run Rotella 15-40 for diesels. I am not a mechanic, where would I attach a manual oil pressure gauge to monitor pressures as it goes from cold to hot? It does not have a oil pressure gauge or new enough to have a...
  9. 1

    Over heating engine

    I have a PC180 LC-3 Komatsu trachoe that over heats after running for a couple hours, the low oil pressure light comes on then also(only when it gets too hot). It cools down faster if I leave the engine running fast vs putting at idle and the low oil pressure light goes off once it cools a...
  10. 1

    Hercules CU2 engine

    Do you have a manual on it?
  11. 1

    Hercules CU2 engine

    a manual would be great to have, thank you
  12. 1

    Hercules CU2 engine

    I am looking for a head for a Hercules CU2 engine from about 1926. A 4 cylinder engine. Does anyone know of someone who parts out hercules engines. Numbers on head are 802 ECU-3 and size C3-11457
  13. 1

    shuttle shift in Case 580C backhoe

    I have a Case 580C backhoe that got low on hydraulic oil and now barely goes in either direction, does a little better once the oil warms up a bit. At times it goes strong in either direction. I notice the drive shaft from the shuttle transmission to the rearend does not spin, so figure it...
  14. 1

    Hercules Model L engine starter

    I have a Hercules Model L engine from the mid -1920's, serial # 70002 and am looking for a starter for it. It is a 3 bolt pattern with 5 inches from bolt to bolt. Engine size 4.5 X 5.75
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top