Recent content by 1954lincoln

  1. 1

    JD 420 ignition point spark

    Hello Should I be seeing a spark forming on the points and could this be the cause of my misfire? I have no decarboned the valves and set the lash yet. I have never watch the points when it was running
  2. 1

    1520 serial ID

    Based on discussions regarding older John Deere equipment, the engine identification code M4MTRgenerally refers to a specific type of engine, likely with 3 cylinders. Here is a breakdown of the likely components of this designation, often found on older tractor engine tags (such as on 1520 or...
  3. 1

    1982 JD 420 Garden Tractor charging issues

    Hello, It’s been a long time since I have been on here with questions about my MT. I was gifted a 1982 JD 420 garden tractor with a Onan B48g engine. I need to check the stator to see if it is working right. The battery light is on and I’m getting 12.19 volts at the battery when running. I...
  4. 1

    2018 JD 1025r oil change

    At what number of hours is recommended for the first oil change? I haven been reading online at one point it was 100 hours and another it was 200 i have 85 hours on it now They said if you change it early that you need to add zinc to the oil. Any recommendations? Mike
  5. 1

    2018 1025r

    Thank you for your reply. I could not find my manual and I found one to download. I saw the one on top. I was thinking, Oh man I hope I didn t miss something. I have been looking into changing the oil , I m at 81 hrs. Some say 100 hrs and some say it changed to 200hrs. That seems high to...
  6. 1

    2018 1025r

    Hello I have 2018 1025r. I had used it a bunch in dusty conditions and needed to clean it out I pulled off the side panel and noticed an oil cap up front on the right hand side. What goes in there and how much if any. Thanks Mike
  7. 1

    2018 1025r

    Hello I have 2018 1025r. I had used it a bunch in dusty conditions and needed to clean it out I pulled off the side panel and noticed an oil cap up front on the right hand side. What goes in there and how much if any. Thanks Mike
  8. 1

    MT oil filter

    Thats what i ended up using a big washer
  9. 1

    Starter will not turn over

    I did some more searching on youtube for 6 volt starters and came across a method to reset it by using a wire whee!.
  10. 1

    Starter will not turn over

    Hello Jim, Thank you for the picture. I see what you are saying. I went ahead and pull the one out of the car and cleaned it up and the bendix is also not snapping back but the motor is new on the inside. I will have to look for a bendix.
  11. 1

    Starter will not turn over

    I was able to take it apart and clean it up real good. I was using my 6 volt battery from the MT and i dont know of 700 amps is enought to spin it good. It stated spinning slowly then sped up. I had some cheap cables too. How do you tell if the bendix is good or not. You guys were...
  12. 1

    Starter will not turn over

    Thank you john I checked the segments and they were all open You can tell im not thet experienced with a meter Can you explain the post Nd the case? I did not under stand that part When i check the post and the brushes i get .7 ohms on 2 and open on the case.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top