(800) 853-2651
SHOP NOW

Recent content by 450dieselfan

Yesterday's Tractor Forums
  1. 4

    806 steering

    ok thanks ill look at the pressures and see what they tell me
  2. 4

    806 steering

    I have a 806 diesel that when it gets cold out the steering doesn't work till the oil gets warmed up. I changed the hyd. oil and filter last season (no water or dirt that I seen). also if I shut it off and start it back up I will have just a moment of power steering before I lose it again. is my...
  3. 4

    2390 powershift problems

    I should have added this in the first post, but this tractor has the pto clutch out and all of the clutch material is in the oil then come to find out the hyd filters were not in place so the system has clutch material in it. this is why I started cleaning the valve body
  4. 4

    2390 powershift problems

    my 2390 doesn't move in the 2 and 3 ps but will move in 1 and reverse ps. I took the valve body off and disassembled it and cleaned everything. checked psi before I cleaned it and after. had low psi on c2 (80psi) and c3 (45 psi). c1 and c4 have 200 psi after I cleaned the valve body c2 had over...
  5. 4

    820 light switch

    dose anyone know were to get a replacement switch for a 820 pony start? had one sit close to a shed fire and burnt all the dash so the original one is junk thanks for the help.
  6. 4

    656 Hydro won't move update

    this maybe a dum question but are you sure the range lever is moveing gears? is it a possibility that a roll pin is broke somewere? maybe the shift fork? just a thought
  7. 4

    mw 9 speed question

    Tryed it again this time I held the clutch in and pushed the lever down when it was coasting and it felt like it was being pushed in and out. Also I looked at the coller it moves about 1/2 in or so from what I can see in the front it stops at the pins and the back it felt like it was tight to a...
  8. 4

    mw 9 speed question

    I just started a m that had been sitting it has a 9 speed with a lever on the side. when I first put in gear it didn"t move but I moved the lever up it was in high. after moving the lever a couple of times it finely was in normal. but I moved it again and it is stuck in high and wont change. the...
  9. 4

    656 3pt

    i have a 656 that has sat for some time i finally got it running and the 3pt will only go up if i move the hyd remote levers making the system bypass. any ides to what is causeing this?
  10. 4

    1468 crank pulley

    im looking for a harmonic balancer for my 1468, has anyone else had this issue what did you do? will one from a newer truck engine work or possibly one from a different application? thanks for the help
  11. 4

    1468 engine parts

    I am looking for a good place to get some parts for my 1468 need an exhaust manifold, and a harmonic balancer. thanks for the help
  12. 4

    Looking at a 1468

    Are they any issues with the dv550 found one that has around 3600 hrs? Are there parts avilable for them? the tractor it"s self is in good condition with normal ware. Thanks
  13. 4

    650 diesel governer

    do I run that in the pump itself or in the fuel mixed? I should have said that it had been sitting for awhile before I bought it and the pump dose get fuel in it too but I always turn off the fuel so it doesn't go in the engine.
  14. 4

    650 diesel governer

    my 650 wants to go to full throttle but if I play with the lever and shut off the fuel and then bring it back to idle or a little higher it will stay for a little bit then start speeding up. when I pull equipment the throttle can be set where ever I want it doesn't surge and is right there to...
  15. 4

    450 injectors

    ill try a compression test and see what it tells me as far as the bleeder I open them just enough to hear a miss. I had it running about 1000 rpms thank you for your help
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top