(800) 853-2651
SHOP NOW

Recent content by 53 diesel

Yesterday's Tractor Forums
  1. 5

    300 engine replace with m

    thanks for your reply, I thought it wouild not work but had to check. 300 is lockep up and m was going to be real cheap
  2. 5

    300 engine replace with m

    I"m sure this has been discussed before but can not find it, will an engine out of an m fit in a 300. Sure it would take some mods but will it fit?
  3. 5

    Chevy 1 Ton Tag Question

    should be rated at gvw stamped in door frame, dot will go by this.
  4. 5

    brillion ss-961

    after much investigation and discussion, have decided to calibrate old fashion way. I will fill one half with seed and turn shaft 345 times and measure seed weight, times two and that will be correct pounds per acre. thanks for input to all
  5. 5

    brillion ss-961

    I have realize seed rate is low, my question was about setting on drill and if number was to be on left side of bearing or right side.
  6. 5

    brillion ss-961

    borrowed a brillion from neighbor, need to set rear box for alfalfa. seed man says to use 2.5 lbs per acre if we plant grass along with it, rear box is set with micro-nut, is number to be seen by outside nut or inside nut?
  7. 5

    schwart spindle

    looking for reasonable for spindles for wide front axle, fits jd 3020 and 4020. need left side, any info would help
  8. 5

    Schwartz wide front value

    Where might you be located, may be in the market for a wide front for my fifty.
  9. 5

    another from the past

    I;m just finishing tear down on a 53 3100. Going to install a 4bt cummins and 700r4 in it. Leaving at stock height and adding only adding a few goodies.
  10. 5

    50 wide front end

    ya i know about turning, my fields arer set up in a way as to turn at ends without any problem. how hard is is it to find wide axle/
  11. 5

    50 wide front end

    trying to decide if a wide front on a 50 would be a prudent item to install, would like to use 50 for a rake tractor and wide would straddle windrow better. could us constructive advice
  12. 5

    cat 3406 adapter for engine stand

    3406 adapter plate is square and mounts to 4, 3/4 inch fine thread holes in pump side of block. Pattern is large and spacers need to be btween plate and block. remove fitting for water line from air compressor
  13. 5

    12.12.12

    Today was my birthday and was born in 59, makes me 53! Was a great day indeed.
  14. 5

    welders

    thanks for help, will continue my search for more info
  15. 5

    welders

    I have used miller equipment at work and welded both steel and aluminum, with mig units and spool guns. I also use a cheap mig at home, wire sticks and is flux core. When welding heavy iron I use and older Lincoln buzz box. My interest in new equipment is for a project in older body work ie...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top