-
6
More help please…
Is this spring retainer bracket for the governor compensating spring mounted correctly? It “appears” it should be flipped putting the hole towards the battery tray? I’m ordering a new spring and don’t have the old one. Thanks!- 65Camp
- Thread
- Replies: 5
- Forum: Ford 9N, 2N & 8N
-
6
Little help please…dust cover?
I’ll use the ones shown in my photos. Thanks!- 65Camp
- Post #5
- Forum: Ford 9N, 2N & 8N
-
6
Little help please…dust cover?
They will be the ones I’ll use. Thanks for your help!- 65Camp
- Post #4
- Forum: Ford 9N, 2N & 8N
-
6
Little help please…dust cover?
Guys I have an assortment of dust covers. The one in the photos fit the best but I’m pretty sure it’s not correct? If not do you have a photo you could share? Thanks!- 65Camp
- Thread
- Replies: 4
- Forum: Ford 9N, 2N & 8N
-
6
Piston rod for lift cylinder.
Thanks for the compliment and your help sir!!- 65Camp
- Post #5
- Forum: Ford 9N, 2N & 8N
-
6
Piston rod for lift cylinder.
Is the rocker splined as well? I’m guessing yes and maybe the shaft shifted through it too? The shaft was definitely sticking out farther on one side. I was able to center it pretty easily. But from your photo it appears the rod cannot fall out of the cylinder. I put a new cylinder in last year...- 65Camp
- Post #3
- Forum: Ford 9N, 2N & 8N
-
6
Piston rod for lift cylinder.
I go to install the lift arms and I notice the lifting shaft was sticking out about 1 1/2” farther on one side than the other. So I pushed the shaft over to make it equal on both sides. I’m not sure how that happened but here is my question. Is it possible for the piston rod to fall out of the...- 65Camp
- Thread
- Replies: 4
- Forum: Ford 9N, 2N & 8N
-
6
Cleaning up my 8N for a little paint!
Yes sir! I realize the original red is darker than the sunrise. However, I’m not building a show tractor. Sunrise is ready available and in rattle cans too for some small parts.- 65Camp
- Post #20
- Forum: Ford 9N, 2N & 8N
-
6
Cleaning up my 8N for a little paint!
Main chassis is in primer. Now off to the million small parts! lol- 65Camp
- Post #17
- Forum: Ford 9N, 2N & 8N
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy