(800) 853-2651
SHOP NOW

Recent content by 706 Farmall

Yesterday's Tractor Forums
  1. 7

    706 Farmall

    Thank You, This worked Great
  2. 7

    706 Farmall

    Thank You, This worked Great
  3. 7

    706 Farmall

    Thank You, This worked Great
  4. 7

    706 Farmall

    I am looking for clarification on a Post that the Tractor Vet posted December 2 2012? I am working on a 706 Farmall 1964 with a TA. The question in Reference to Adjusting Clutch and Dump Valve adjustment? The Tractor Vet states to Hold the transmission Brake lever back against the gear and...
  5. 7

    Cub Cadet 1512 Kubota (3) Cylinder Diesel engine

    I have a Cub Cadet 1512 , it shows the Hydro Pump as 717-3033 in the parts manual? I pulled the rear out of the Tractor, and I cannot find a manufacturer name on the Hydro. It does have a Name Plate with 90-1225 CCW 05-85-13-20430. I pulled it because the seal in front of the Charge Pump...
  6. 7

    Head Gasket

    I am told it is not the Hercules motor. The Hercules has a separate bell housing and motor, this is all one piece. The dealer told me this was a John Deere engine. There is no serial number on the tractor.
  7. 7

    Head Gasket

    I am rebuilding a John Deere L engine. The head gasket I removed was a metal type gasket, the New One from John Deere is just material fiber. Is this really going to hold up and seal? The John Deere dealer said that is how they are made now. I am worried that it will not last. Thanks for...
  8. 7

    John Deere L Engine Rotation direction

    Thank You for the Replies.
  9. 7

    John Deere L Engine Rotation direction

    What is the Correct Rotation for a John Deere L engine. It is not the Hercules Engine. Is the Rotation Clockwise or Counterclockwise? Is this from the front of the engine or the rear of the engine? Thanks Just wanting to verify the valve timing before I put it back together. I did...
  10. 7

    John Deere L Engines Torques

    1940? John Deere L engine Torques? Where can I find the torque values and valve clearances for a John Deere L? Thanks
  11. 7

    1935 John Deere B

    If you mean did I make sure all passages were clean ? Yes, removed all Brass plugs and cleaned all passages. I did not drill them Open more just found the drill that were the right size for the passage. Thanks
  12. 7

    1935 John Deere B

    I will need to check the float level. Thanks
  13. 7

    1935 John Deere B

    I can screw in the idle jet without much change , I had the carb completely dismantled and cleaned everything? Thanks
  14. 7

    1935 John Deere B

    I had the Mag looked at and the guy said it was Good.
  15. 7

    Question

    I have not been on here for quite a while. Is the Tractor Vet still on here? Thanks
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top