-
A
Ford 600 clutch problems
Pictures of the parts for my Ford 600- afry59
- Thread
- Replies: 0
- Forum: Restoration Processes
-
A
clutch on 4 speed Ford 600 tractor
i have a ford 600 4 speed tractor. new throw out bearing, clutch, pressure plate and pilot bearing. replaced all and put back together. i have no adjustment for some reason it fells like the throwout bearing is not making any contact with pressure plate. please help -
A
Ford 600 clutch problems
Freeplay is good throw out bearing does not touch the pressure plate- afry59
- Post #1
- Forum: Restoration Processes
-
A
Ford 600 clutch problems
yes throw out bearing does not reach the pressure plate fingers- afry59
- Post #1
- Forum: Restoration Processes
-
A
Ford 600 clutch problems
I have a 600 4 speed tractor that I have replaced the clutch, pressure plate and throw out bearing. After putting it back together I have no adjustments that I can do to get the clutch to release. I know the throw out bearing is moving like it should. Could the pressure plate fingers need to be...- afry59
- Thread
- Replies: 7
- Forum: Restoration Processes
-
A
Ford 600 clutch problems
How would I no how far out the pressure plate fingers should be. Is there a process to adjust the fingers -
A
Ford 600 clutch problems
Well I've gotten the tractor split again and have a few pictures, I done this before a long time ago and I know it's something small. I've checked the new parts and they match the old parts so I don't think it's a parts mistake. The pictures show the new parts installed, any help will be... -
A
Ford 600 clutch problems
I'm going to split again tomorrow can't be that hard to figure out what I'm doing wrong -
A
Ford 600 clutch problems
It is a 4 speed and no matter which way I adjust the nut I have no clutch pedal, it stays in gear. This is the adjustment screw I'm talking about. -
A
Ford 600 clutch problems
I just replaced the clutch, pressure plate,throw out bearing on my Ford 600 and I don't have any adjustments. What did I do wrong. It like the throw out bearing is not engaging the pressure plate..need help please
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy