(800) 853-2651
SHOP NOW

Recent content by ajcoc

Yesterday's Tractor Forums
  1. A

    Best quality line for weed trimmer??

    Throw the string head away & put a blade on. Stihl dealer did that for me15 yrs ago & I will put a new blade on this year.Blade will cut .5 trees as well as big weeds no problem.
  2. A

    D-17 question. What is this lever

    To put belt pulley in gear. Rod with hand knob goes through hole in lower right corner of dash below tack meter to operate lever.
  3. A

    A/C question again

    Put a manual shut off in your heater hose.
  4. A

    OT stanky basement!

    Sorry- should be ozone generator.
  5. A

    OT stanky basement!

    JD has a good suggestion. The dog got skunked & I shot the skunk against the back of the house. MY coat was hanging in the kitchen & when I went in any building people held their nose. I got another coat & a friend loaned me his oxygen generator for a week.Smells much better now. Google OX...
  6. A

    D17 Battery Polarity has Reversed

    I dont have a wiring diagram here but i think I think on mine you have to use the original resister? or diode? to stop engine when you turn the key off. It is mounted under the gas tank on mine.
  7. A

    D17 Battery Polarity has Reversed

    To mount an alt on a d17- cut a piece of 1 in. rod to fit between the mounting ears on bottom of alt. Drill length ways for mounting bolt 3/8. Cut left front motor mount flanges to allow 1 in rod fit 1/2in. down between flanges . Put gen. pulley on alt. to clear power steering belt. Set...
  8. A

    Cutting tin

    I bolted 2used road grader blades together at 1 end to make shears. Got worn out blades from local twp. garage for very little cash.
  9. A

    Re: F/F2 edible bean header

    IT worked good when i grew white beans. I am 45 miles from Port Huron.> Sarnia Ontario if you are intreested.
  10. A

    Re: F/F2 edible bean header

    I have martin mcarther head like that off an F? changed to fit my M2 .Have not used for 20 years but stored inside.
  11. A

    Stihl 026 carb RR

    When my 026 got to taking 10 to15 pulls to start if cold I drilled a small hole in cover over air filter. PUT mixed gas in a plastic squirt bottle & give it a shot into air filter. Starts first pull every time now.
  12. A

    Did myself a hurt.

    I put self drilling screws with hex heads in the edge of my boot heels &soles. sure helps walking on ice. Not good on the house floors ac.cording to wife
  13. A

    case 850D dozer muffler

    Tessi exhaust 3526 White Oak Road London Ontario Canada N6E 2Z9 1800 835 381 or 1 519 681 3582 ext 228 will make any muffler a lot cheaper than any dealer.
  14. A

    Replacement Raddle Chain Woes

    Bauman Manufacturing Limited -Elmira Ontario Canada will make any chain you need. www.baumanmfg.com
  15. A

    91 F250 Driveline Vibration

    Fixed my truck drive shaft vibration with hose clamps . took few tries to find right spot.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top