Recent content by avant tractor

  1. A

    Minneapolis Moline U

    I have run across 2 propane U's for sale, one is according to the owner rebuilt with new tires, has not run in several years (kept in barn), the other is parked outside has not run in several years either. Both are wide front ends. I am told they both will run with some propane and a new...
  2. A

    856 Injectors

    I have an 856 and need to pull the injectors for testing. I have done some reading in a repair guide. Are there any tricks that make the process easier? Thanks
  3. A

    farmall 806-Starter problems

    I am getting forgetful. This is a propane engine so it only has 1 battery
  4. A

    farmall 806-Starter problems

    I forgot to mention, I have a new battery as well.
  5. A

    farmall 806-Starter problems

    I am having problems with the starter on my 806. I had the starter rebuilt by a reputable shop, but when I try to start the tractor I have to push the starter button several time before the gear on the starter catches the ring gear. I took the starter off and to it back to the shop and watched...
  6. A

    1466

    They told me that the tractor had been used to operate a 10 ft 3 pt shredder for about the last 10 years & it had not been used in the last year or so. They told me "it starts right up".
  7. A

    1466

    I am considering buying a 1466. Can anyone tell me about it in general. Strong and weak points. I know nothing about them and I found one relatively inexpensive. All I have seen is a picture. I have an 806 & 856 and they work very well, can I expect the same dependability from a 1466? Thanks
  8. A

    starter problems

    I am having issues with the starter on my 806 LP tractor. I had it rebuilt at a reputable shop and put a new soleniod on it. when I hit the starter button the soleniod does not engage the ring gear, the starter just spins. I took the starter off and took it back to the shop, they checked it out...
  9. A

    Farmall 806 propane problems

    This is just an FYI, I have an 806 that I have owned for about 5 years, I last used it in November, all was working fine when it was parked. I went to use it in Feb. and it would not start, I put a new vaporizer on it, new plugs, cleaned the carb, checked each plug for spark 2 different times...
  10. A

    Propane parts

    Does anybody know anything about Jrs Propane Parts out of Redford MI. I ordered a kit for an impco epavorater on 4-24 and still have not received any parts, and they will not return my calls, I cannot reach a warm body, I am asked to leave a message. They will not return my emails either.
  11. A

    Miller Big 40

    I have a Miller Big 40 welder with a continental engine on it. I converted it to electronic ignition. Now I need to reset the timing, but the distributor is stuck. I have sprayed it with various types if lubricants, but still stuck. Any ideas. Thanks
  12. A

    Farmall 806 propane

    I forgot to mention. I have an impco model E vaporizer on the tractor
  13. A

    Farmall 806 propane

    My 806 propane will not start. It was running great. it has been setting for about 5 months. The other day, I was going to use it, it started up and ran rough for about 3 minutes, then died. I have fire to the positive side of the coil, and to each plug. The tank has about 70% fuel and the fuel...
  14. A

    chewy

    I have a farmall 856 that runs good. The last year or so it has started throwing diesel out the exhaust, to the point that it is covering about 1/2 the hood. I was told to run it hard and it would clear up. I did run it hard and it did clear up, but I have been feeding hay with it and it has...
  15. A

    farmall 856

    lately, I have not worked it very hard. Just doing a few light things. So sounds like I need to work it and not worry about it. Thanks
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top