(800) 853-2651
SHOP NOW

Recent content by AZ GhostTown

Yesterday's Tractor Forums
  1. Bruce from Can.

    880 Massey plough

    Did Massey build the 880 plough ,or did someone build it for them and they badged it and sold it through their dealer network?
  2. 2

    3010 rear side shields. Anyone need one?

    Cleaning out my shed, & found 2 of them both right rear side, both in very good condition. Decal says 3010, might fit a 3020 also. I'd take $30 a piece for them. YES they were listed in the classifieds.
  3. G

    Hydraulic fluid

    I have been using 10w40 in my T20 for years. I have been fixing up an 8N Ford. Fords call for universal transmission fluid. Why not use universal hydraulic fluid in the Ferguson transmission. Ford N models and Fergusons use the same rebuild kits for the hy-pumps. The pumps must be the same. What...
  4. Hendrik

    OT Purple lights for funeral processions

    Did you ever see purple lights or flash lights on hearses or other vehicles used in funeral processions/corteges? (The purpose being to warn/inform other drivers that a funeral is taking place.) We heard that they are being used somewhere in Canada. Does a cortege have any special rights in the...
  5. R

    Timing a MT226D diesel

    Hi guys, I need to know if anyone can tell me how to time a S4e Mitsubishi engine. It is a 4 cyl diesel in a MT226D tractor. It's a grey market and no books yet for it. It is very slow to rev up rpm's especially under a load. I've changed all filters andit still is kinda slow, if under a load it...
  6. B

    MD power steering pics

    does anyone have any pics of an MD or SMD power steering pump mount. just wondering which bolts are used to mount and how the belt adjustment is accomplished. thanks.
  7. D

    John Deere model RC

    On My Tractor.ca they offer parts and accesories for a John Deere model "rc" tractor.I thought it may be generic parts for row crop tractors but not sure.Any guesses or ideas?
  8. A

    188 diesel

    I am looking for either a 188 case diesel engine or a good short block. I need one for in a 1845 skidsteer. I would be very thankful for any help in locating one. Thanks again.
  9. A

    Loader Controls Placement .... what's right???

    I have two tractors each with a loader. An NAA and Ferguson TO-30. Both loaders are the same design, I believe Dearborn. Controls are mounted on the right side of each with the NAA lift on the inside and tilt on outside. TO-30 just the opposite. Is there a standard? I need to change the...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top