-
B
Ford 340A brake sticking
I did notice the grease fitting and in hindsight that should have been my clue. I've ordered a new fitting and bushing along with some new springs. thx.- bcharest
- Post #13
- Forum: Restoration Processes
-
B
Ford 340A brake sticking
No, you weren't missing anything. I misunderstood how the whole thing works. This makes a LOT more sense! I'll get it all cleaned up, maybe replace the bushing and report back. Showcrop, you must be near by if you know John and Jason. Awful nice folks. Thank you all again.- bcharest
- Post #11
- Forum: Restoration Processes
-
B
Ford 340A brake sticking
Finally got the brake pedals off. Seemed like it would be an easy job but tough sledding to get the first, right, pedal free. Not much room to work or swing a hammer with the backhoe and loader frames right there. Attached is a pic of the shaft the pedals connect to as well as the parts diagram...- bcharest
- Post #8
- Forum: Restoration Processes
-
B
Ford 340A brake sticking
Hi Used Red MN, all. The problem has went away at least for now but I did use the differential lock a number of times recently including just before this issue happened. I just took a few measurements and if I lift the lock pedal up with my hand or foot and then release it, it drops about 1/4"...- bcharest
- Post #5
- Forum: Restoration Processes
-
B
Ford 340A brake sticking
The brakes occasionally make a kind of dragging noise and yesterday when I was driving down a 10 or 15% decline the right wheel would turn and then lock for a second or two while I wasn't touching them. A couple days ago I couldn't get the tractor to turn in my dirt driveway. I turned the...- bcharest
- Post #3
- Forum: Restoration Processes
-
B
Ford 340A brake sticking
Hi folks. New posting here so hope I'm in the right thread. I've a 1983 Ford 340A Industrial Tractor with a backhoe. The right rear brake seems to be sticking, my land is not super level and the hoe makes in light in the front so I'd like to fix the brake before it causes a mishap ending my...- bcharest
- Thread
- Replies: 13
- Forum: Restoration Processes
-
B
Ford 340A backhoe bolt
You are the hero of the day! N801630S100 - Bolt - M24 x 3 x 75 - NEW HOLLAND AGRICULTURE. Thanks very much and take care.- bcharest
- Post #3
- Forum: Tractor & Farm Talk
-
B
Ford 340A backhoe bolt
I have an 83 Ford 340A industrial tractor with a backhoe. The hoe attaches to its frame with 3 bolts on either side - one on top and two below. The two below travel thru a plate and into the hoe frame. I'm assuming someone tried to take the backhoe off at one point because one of the two...- bcharest
- Thread
- Replies: 2
- Forum: Tractor & Farm Talk
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy