(800) 853-2651
SHOP NOW

Recent content by beetlefarm

Yesterday's Tractor Forums
  1. J

    lgt 18h

    does anyone know where i can find disc brake pads for this ford lawn mower ser yc 00388
  2. J

    Ot, metal roof question!

    I have always nailed or screwed metal roofing down on the high part of the sheet metal, I got some metal for my barn and my friend said to screw it down on the flat part of the sheet. How so you do it. Thanks J
  3. D

    Filler plates in small grain?

    I usually use my JD 45 combine in corn.I have about 4 acres of triticali.can I just leave the filler plates in for this small aCREAGE?or will they cause problems-like plugging?Thanks,Steve
  4. J

    Raygo 420A 1970 PAVER

    Would anyone know if this unit uses a tractor Hyd. fluid for it's hydraulic system or a straight TO-4 10W FLUID.
  5. A

    4020 Starter

    REcently posted starter problem on 4020 JD.Ended up being bad ring gear on fly wheel.Thanks for your input.GP
  6. L

    International I 9 Gas

    What is a International I 9 Gas worth? It has a Z code engine block so i assume its a 350ci instead of a 335. Rear pintel hitch been ruined by blue wrench. Runs drives is painted green? with red underneath. Solid rear centers with weights and W9 like front wheels and axle. fenders dinged...
  7. D

    H bolster

    I am planning to pull the bolster on my H to change the front timing cover and install live hydraulic pump. I rebuilt the steering gear last year and would prefer not to take it apart. Can I take the pin out at the middle knuckle and pull the shaft with the bolster?
  8. L

    over/ under

    Will a sherman over/ under out of a 8n, fit a 640?
  9. J

    2096 5.9 cummins

    Does anyone know if a 5.9 cummins that is used in a 2096 will bolt direct in a 2090? Thanks Jerry
  10. A

    160 AC clutch

    replacing clutch in 160 AC big job or normal clutch job
  11. L

    4430 ENGINE EXCHANGE

    4430, TO REMOVE THE ENGINE DO YOU HAVE TO REMOVE THE CLUTCH. THANK YOU
  12. B

    DB1200 rad.

    Hello; anybody know where i could get a new radiator for my David Brown 1200 selectomatic?? Some place in the U.S.A. maybe? Thanks.
  13. B

    DB1200

    Hello. Anybody know where i may find a front end loader for my David Brown 1200? I haven't seen too many with loaders attached. Or maybe if one from a different model D.B. or Case tractor will fit.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top