-
D
OT Chevy Avalanche question
Strange humming noise by rear of truck like a struggling whine. I can only guess my in tank fuel pump is about to fail? { 2002]- dr sportster
- Post #1
- Forum: Tractor & Farm Talk
-
B
seafoaming a tractor
I've tried seafoam on gas engines, and frankly have not seen any improvement. I suspect it is highly over-rated. -
B
Ford 555A Won't Move Forward/Reverse
Ford 555A backhoe. The clutches and torque converter were all repaired 2 years ago, so I think they should be OK. I was working with it, backed up, shifted to forward it won"t move. Put in reverse it won"t move either way. A guy at the dealership told me it might be the modulator valve. Is... -
B
Vewrtical Exhaust for Jubilee
Howdy guys, A friend is trying to install a vertical exhaust on his Jubilee. The kit he has tried does not have two 90 degree bends and doesn't fit. Sheet metal and headlight interference. Other kits appear to be from the same source. Can anyone tell me where to get a vertical system that... -
B
Oil Pressure Port on a Ford 600 Series Tractor
Thanks JMOR and Soundguy. I knew it had to be in a difficult spot! -
B
Oil Pressure Port on a Ford 600 Series Tractor
Can anyone tell me where the oil pressure line attaches to a 600 series engine? -
B
Hydraulic Clutch Bleeder Valve - Ford 5640
Can anyone tell me where the bleeder valve is for a 5640 with hydraulic clutch? -
B
Head Bolt Torque Spec for a Ford 7700
Howdy, Does anyone have the proper torque value for head bolts on a "79 Ford 7700?? I assume they go up in sequence like my tractor"s engine: 90 ft-lbs, then 100 ft-lbs, then 110 ft-lbs. Thanks for your help. -
B
New Holland 6610S key switch wiring
I obtained the following from a supplier regarding terminal identification on your key switch: 1- Battery feed into switch, (also headlights connect here) 2- Accessory wire, 3- Thermostart, manifold heater, 4- Gauges illumination, warning lights, 5- Safety switches & starter solenoid. -
B
PTO not working NH TL100A
A friend asked me to look at his TL100A to see what was wrong. The PTO doesn"t work. I was told it could be two things: The switch or the solenoid. I think the switch that turns on the PTO is working, but I"m not sure. I can"t get to the wires on the switch to check. The two solenoids on the... -
B
Locating Pin on seat retaining stud
THANKS, sotxbill and Soundguy. I really appreciated your help. A friend helped me apply a little bit more force on the rocker and she lined up fine. It wasn"t an alignment hole, it was an alignment slot. Thanks again. You guys are lifesavers. -
B
Locating Pin on seat retaining stud
I have a Ford 3600 and am trying to start into a little restoration. On removing the seat assembly, the rear retaining stud came out completely as the nut was seized. It then became obvious that the stud was also some kind of locating pin (internally). My problem now is that the pin won't go... -
B
Ford 6600 running a 540 rpm potato digger
WH, thanx for your response. This is probably the most practical solution. I recommended that he try various engine rpm's and see what works best for him. -
B
Ford 6600 running a 540 rpm potato digger
Aw, they only want $7K+ for it!! Out of the question.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy