(800) 853-2651
SHOP NOW

Recent content by bigdieselman

Yesterday's Tractor Forums
  1. B

    ih d268 engine

    put in a IH 358 diesel , will bolt right in
  2. B

    Ford 8N nightmare

    Im fixing it for a friend, he said it ran very poorly, so I dont know what he did, but Im a good diesel man. I pulled the didtributor out 5 times, checked the gear, when #1 is TDC the rotor will never line up with #1 on the cao when the points are starting to open, never. could the gear train be...
  3. B

    Ford 8N nightmare

    In need your help. I m working on a Ford 8N with a side distributor we cannot get the engine to time correctly Each cylinder has 120lbs compression and when number 1 cylinder is on top dead center the rotor points away from number one cylinder on distributor cap We have done all the adjustments...
  4. B

    504 IH runs very rough

    yes I retimed the engine, compression was 110 to 120 lbs all cylinders
  5. B

    504 IH runs very rough

    Im working on my neighbors IH 504 utility tractor, hes been sick for 3 years, getting better ask me to get it running. did a complete tune up new plugs points condenser coil, adjusted the valves, cleaned the carburator but it still runs very rough, back fires, smokes wants to die out. I done all...
  6. B

    IH W4 with stuck clutch

    my McCormick W4 been setting in the barn for about 4 years got it running but the clutch plates are stuck to the flywheel. any ideas without taking the bellhousing half cover off. thanks for any help
  7. B

    Farmall 340

    is this a rare tractor ? I see 340 utility tractors but never a farmall
  8. B

    Ford 9N

    my brother has a Ford 9N on the grille near the top has a medal madalian that says Ferguson System. Is that an early 9N, i have never seen that before
  9. B

    turbo boost

    dozer is too old for a waste gate, has no muffler, staight pipe. I will has to pull turbo off and check rotation. Thanks for all the feed back
  10. B

    turbo boost

  11. B

    turbo boost

    I farm 1200 acres with my son and this fall we purchased at a dealer auction a 1971 Cat 824B wheel dozer to use on our farms. Cat runs real good with no load but if you put the coal to it under load she bellows black smoke. It has a Cat D343 six cyl engine turboed and after/cooled. we took out...
  12. B

    Ford 2000 lift problem 3PTH

    OK where is the uunloading valve ? the pump is putting out pressure
  13. B

    Ford 2000 lift problem 3PTH

    helping a friend with his 2000 Ford with 4 cyl. gas The 3 point wont lift, pump has good pressure. Took the 3 x 5 plate off the front of lift cover and oil comes out hole to the right. We put compressed air in the port hole to the left of the check valve and the lift arms raise. Could the...
  14. B

    Ford 841 3PH will not raise

    helping a friend he just purchesd this tractor and 3PTH wont raise, any ideas ?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top