-
B
high torque starter for oliver 77
Call Maibach tractor in Ohio, 1-800-808-9934, Talk to Brad. Cost around $250.00- bigdog88
- Post #1
- Forum: Tractor Pulling
-
B
Offset grind a crank
look, if you offset grind a crank 1 inch you will get 1 inch of stroke. you grind the 1 inch off of the inside of the journal thus when the piston is at bottom dead center it is 1 inch deeper in the hole and when it is at top dead center it is at the original heigth. all of you go look at what...- bigdog88
- Post #1
- Forum: Tractor Pulling
-
B
Offset grind a crank
looks like a lot of you don't really have a clue what you are talking about, offset grinding a crank like a 99 oliver with i think a 2 5/8 journel and using c farmall rods with a 1 3/4 journal will give you just under 1 inch of stroke which is all picked up on the down stroke, leaving the...- bigdog88
- Post #1
- Forum: Tractor Pulling
-
B
motor oil for pulling tractor
a lighter oil will cut down on the resistance that the crank incounters when it goes through the oil, but you could be compromizing protection, I use a good 30 weight and have had good luck with it.- bigdog88
- Post #1
- Forum: Tractor Pulling
-
B
14.9X38 Firestone tires
14.9 were made for 13 inch rims, if you want to change what's your price for the 14.9s- bigdog88
- Post #1
- Forum: Tractor Pulling
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy