-
B
Splitting 8n - any recommended activities?
'49 8N, broke 2nd gear about a year ago, and I'm finally getting to fixing the thing. Is there anything I should definantly do while it's split? I think the clutch is ok, but I can probably confirm that from the look of it. The PTO seal is on my list, as it's leaked since I got the thing. I...- Bigsteve
- Thread
- Replies: 5
- Forum: Ford 9N, 2N & 8N
-
B
8N stuck bad
Ok... The ground was finally firm enough for me to jack it up with my hi-lift. I got the back end up, turned the engine backwards with the chain wrench, pushed the wheel with my foot and was able to pry the gears back to neutral. It wouldn't start (I'm pretty sure water got up to the...- Bigsteve
- Post #1
- Forum: Ford 9N, 2N & 8N
-
B
8N stuck bad
I got my 8N stuck in the mud about a month and a half ago. In my efforts to get it out, I got it stuck in reverse and 2nd... I cannot get the engine to turn backwards to remove the tension; I've tried using a screwdriver on the flywheel as well as a chain wrench on the front pulley. I tried...- Bigsteve
- Thread
- Replies: 7
- Forum: Ford 9N, 2N & 8N
-
B
Sabre model 530 cutter bottom seal
So I got a sabre model 530 rotary cutter for the right price (pull it out of the woods and it's yours). The bearings feel fine; I gave the shaft a few turns and everything moves smoothly. The bottom seal is completely gone, however. Does anyone know what size seal it uses (or where to measure...- Bigsteve
- Thread
- Replies: 0
- Forum: Implement Alley
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy