(800) 853-2651
SHOP NOW

Recent content by Bill C

Yesterday's Tractor Forums
  1. B

    Ind PTO clutch

    Where is there a write up on how to install the pins and springs that you get when you buy the new parts from Massey that do not use the wave springs. bill
  2. B

    gravely 816g hydraulic reservior

    Where is the hydraulic reservoir for this model located
  3. B

    MF265 Independent PTO

    I bought the parts to rebuild the clutch pack from my MF dealer. The original pack had wave springs and disk with coating. The parts they sent me have 11 springs and pins,7 plates and metal disks. I need help in putting it back together with the new parts. I can't find any wright ups or pictures...
  4. B

    200 pto

    Did all 200 have 540/1000 PTO or is 1000 an optional feature. Thanks, Bill
  5. B

    NH 847 tail gate replacement

    Need help on how to get the tail gate off
  6. B

    MF265 3 point hitch lift arms stuck all the way up

    We were able to drive the lift arms down. We drilled holes in the casting where 100 series has grease fittings and installed fittings and forced WD 40 and grease into them. We then chained the lift arms to a back hoe bucket and raised them up and down for an hour. There is still some friction...
  7. B

    mf 265 lift arms stuck up

    We were able to drive the lift arms down. We drilled holes in the casting where 100 series has grease fittings and installed fittings and forced WD 40 and grease into them. We then chained the lift arms to a back hoe bucket and raised them up and down for an hour. There is still some friction...
  8. B

    Spitting 265 between transmiission diferential

    Do you have to remove the shift cover to disconnect the hose going between them. Thanks Bill
  9. B

    165 Independ PTO Pressure

    Thanks, I checked 2 of my tractors and they both read 200, one has PTO problems so I am going to overhaul the PTO. Bill
  10. B

    165 Independ PTO Pressure

    How much pressure should you see on the port on the PTO side plate. Thanks Bill
  11. B

    MF265 3 point hitch lift arms stuck all the way up

    The roller is there if I am looking at the right thing. Bill
  12. B

    MF265 3 point hitch lift arms stuck all the way up

    Removed the plug and the selector cover on the right, still stuck. Tried to take the lift cover off but it hangs up on the back of the case due to the arms being up. Any ideas? Thanks Bill
  13. B

    mf 265 lift arms stuck up

    I got this mf 265 a couple of years ago. The tractor had set for years with the arm stuck up. I had a post open that has went away. Today I removed the plug on the left front and the selector cap on the right, still stuck. We tried to remove the lift cover, but the arms up prevent you from...
  14. B

    MF265 3 point hitch lift arms stuck all the way up

    We had a big mid-Atlantic snow storm last night, hope to get back to you sometime this week. Thanks, Bill
  15. B

    MF265 3 point hitch lift arms stuck all the way up

    The arms do not move at any time, they were up when I got the tractor
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top