-
R
Oliver 66 fenders
What is the going rate for a nice pair? I have a pair I want to list on the photo adds but not sure where to start. Don't want to Go stupid high, but don't want to get beat up either.- rustyplow
- Post #1
- Forum: Oliver, Cletrac, Co-op and Cockshutt
-
B
8N will not start after installing electronic ignition mod
Good news to report. 8n running fine. Volt tester indicated that 6 volts were going in to ignition switch but on the output side it only measured 4volts which is not enough for EI. Bought a new ignition switch and that cured the final problem. Didn't have to get the new battery or new cables...- Bill Helwig
- Post #1
- Forum: Ford 9N, 2N & 8N
-
B
8N will not start after installing electronic ignition mod
Thanks to all of you for your replies and ideas. I ran the wire from the ignition module directly to the post on the ignition switch side before the ballast resister rather than after it (which several of you suggested might be the problem) and the tractor started and ran great. However when I...- Bill Helwig
- Post #1
- Forum: Ford 9N, 2N & 8N
-
B
8N will not start after installing electronic ignition mod
I have a ford 8N 6 volt positive ground front mounted distributer pre 263....serial number. I ordered and installed an electronic ignition module to replace points and condensor etc. INcluded a new distributer plate. But now it will not start. I followed instructions to install this and checked...- Bill Helwig
- Thread
- Replies: 20
- Forum: Ford 9N, 2N & 8N
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy