Recent content by Bill Mack

  1. B

    160 Fuel injector problems

    So two weeks ago the tractor was running fine. A week ago, I couldn't get it to start. I tried to bleed it, and I'm getting no fuel at the injector lines. I get fuel at the bleeder valve, but nothing at the injector lines. It seems obvious that the injector pump is bad (or clogged, or...
  2. B

    Bleeding fuel on 4600

    Welding man: That is the process I did, except for the throttle part. I'll give it another try today if the rain holds off. Also, I think the fuel level in the tank is low so I might have to top that up. Thanks.
  3. B

    Bleeding fuel on 4600

    Showcrop: I'm not quite sure how to answer. It's an aftermarket pump. This is the type: https://www.external_link.com/fuel-injection-pump-new-cav-lucas-3233f390-121307.html?gclid=CjwKCAjwtNf6BRAwEiwAkt6UQkRanzutr5hpq1CHHdo6x-3XV4W0DL9zcTfANpkHNhsrAw9iqEF_sxoCrpQQAvD_BwE
  4. B

    Bleeding fuel on 4600

    So I finally got the new fuel injection pump installed. I get a good fuel stream at the bleeder valve. I'm just getting a trickle where the fuel line enters the engine. That may be normal, I'm just not sure. It didn't start, but by the time I had it bled and getting fuel through the battery...
  5. B

    4600 Injector pump timing

    That helps a lot. Thanks.
  6. B

    4600 Injector pump timing

    That's the part I don't know about. I've never seen either of these marks but it could be just dirt. Thanks.
  7. B

    4600 Injector pump timing

    So I bought a new injector pump for my Ford 4600. Unfortunately I didn't know about timing before I yanked out the old one. Can anyone tell me what I have to do to make sure the timing is OK? I know there is a notch and key that have to be aligned when I put the pump in. Is that it? Thanks.
  8. B

    4600 draining coolant

    Thanks. I haven't actually pulled the lower hose yet.
  9. B

    4600 draining coolant

    I have to remove the lower radiator hose from my 4600. I'm not sure the best way to drain the coolant. Any advice is appreciated.
  10. B

    4600 removing injector pump

    I think I see it now. I wasn't sure what you guys were talking about when you said the cover. I thought the pump would just slip out of the cover.
  11. B

    4600 removing injector pump

    I don't have a manual.
  12. B

    4600 removing injector pump

    Serves me right for jumping ahead. I removed the starter, but it still won't come out. I removed all the lines, and the 3 bolts, but it only comes out 3/4 of an inch or so and something stops it. The tractor has a loader on it which makes it doubly hard to work on, plus me not really knowing...
  13. B

    4600 removing injector pump

    Can the fuel injector pump be removed without removing anything else, or must I remove the starter first?
  14. B

    4600 Injector pump

    Hi Dieseltech. I sent you an email.
  15. B

    4600 Injector pump

    I saw another thread on here that said if I cut the wire connecting two bolts on top and remove them, I can loosen the metering valve. Sound right?
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top