(800) 853-2651
SHOP NOW

Recent content by Bill Small

Yesterday's Tractor Forums
  1. B

    Oliver 1550 free wheeling

    When using Oliver 1550 with bush hog mower, it wants to free wheel when going down an incline. Should it be in direct drive or hydra drive and will that stop the free wheeling?
  2. B

    Oliver 1550 hydraulics and one way cylinder

    I am trying to use the one way cylinder to unload my barge box wagon using my Oliver 1550. It raises and dumps the load fine, but when I try to lower the wagon box, it doesn"t want to operate. I end up disconnecting the hose, sticking the end in a bucket or can and pushing the ball valve on the...
  3. B

    JD 520 low oil pressure shutoff

    I am having problems with the low oil pressure membrane allowing gas to get into the oil AGAIN !! Evidently this gas we now must use eats the membrane. What solution can anyone offer? Thanks in advance. Bill
  4. B

    hydraulic connetions on Oliver 1550

    I have a terrible time connecting Pioneer couplings on my Oliver 1550. Anyone have a solution? Is there any adapter such as what John Deere put on their new generation outlets, where you don"t have to slide the outside sleeve and push the hose into it at the same time? Currently I have a one way...
  5. B

    Allis Chalmers G air cleaner

    In my A C manual for the model G it does not show a cap on the air cleaner, yet I see them advertised on EBAY. Did the tracor come originally with or without a cap, and is it necessary today to have one?
  6. B

    gamn chainsaw sharpener

    Does anyone have a gamn sharpener for sale, or the instructions for one? Also any parts available?
  7. B

    throttle linkage on L

    To DScott A picture or two would be great. Bill
  8. B

    throttle linkage on L

    With my L, the throttle jumps out. The part has a saw tooth like part that does not stay put. There is a wire spring that a looks like it should provide enough pressure to stay put but does not. This spring is on one side and then a single tail of the spring tries to hold the linkage. Do I need...
  9. B

    John Deere H installing magneto

    Where can I find instructions for installing a magneto on my H?
  10. B

    Wiring diagram for G

    Can anyone direct me to a wiring diagram for and Allis Chalmers G that has been converted to 12 volt with an alternator?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top