(800) 853-2651
SHOP NOW

Recent content by Bison2010

Yesterday's Tractor Forums
  1. B

    1755 cockshot

    OK, thanks it sounds like it could be a bit of a project
  2. B

    1755 cockshot

    It’s a du-al loader. It’s a 2-135
  3. B

    1755 cockshot

    will a front end loader off of 1755 Cox shut fit on a 135. If not, how much work would it take to retrofit it? Thanks.
  4. B

    70 Oliver hart parr

    Saved this one from the scrapper it was pretty rough chloride ate out the rims motor seized started working on it seven years ago finally got it to this point still need side covers but I don t know where I ll find them all original as far as I know except the cut offs
  5. B

    Oliver 1250 Diesel - In search of valve Springs

    What s wrong with your Springs we used to put a valve spring washer underneath if they were a little weak
  6. B

    Oliver 88 he

    How many ton would it take to do this better yet how could this happen pistons and sleeves we re good and the rod bearings any suggestions?
  7. B

    770 oliver

    Thanks for the information. The sending unit was dead check the gauge and it had a reading of 160 ohms put a new sending unit in and read just under 500 homes so I have to put it to work and see what kind of reading I get thanks a lot
  8. B

    Oliver 440 engine rebuild

    If the flywheel is on and there s a timing mark on it line up the timing mark and that should work
  9. B

    770 oliver

    Does anyone know what the Ohms reading should be on the heat sending unit thanks
  10. B

    1800A won't start and I am at a lost?

    Sounds like the coil but could be condenser or appoints. I ve had the same situation a couple of times. You ll get it
  11. B

    Oliver 1365 camshaft and lifters questions

    If there is any pitting or if they re dished at the bottom I would change them because they will give you trouble
  12. B

    oliver 1600 diesel head

    Check the top of the Pistons to see if they re was anything leaking in
  13. B

    Looks like I'm an Oliver man now

    That s a good looking unit
  14. B

    American Bosch psb pump

    I took a couple of those pumps to Olsen Diesel in Yorkton so maybe they can help you
  15. B

    replace front camshaft gears 88 std

    I have the gears and maybe the trust washer I would try Korves they might have everything you need I am in Canada
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top