1755 cockshot

[Bison2010]

will a front end loader off of 1755 Cox shut fit on a 135. If not, how much work would it take to retrofit it? Thanks.

 

[rrlund]

will a front end loader off of 1755 Cox shut fit on a 135. If not, how much work would it take to retrofit it? Thanks.

Depends on the loader. I think the biggest issue would be the cast in weight bracket on the 135, that's if you're talking about a 2-135 White.

 

[Bison2010]

Depends on the loader. I think the biggest issue would be the cast in weight bracket on the 135, that's if you're talking about a 2-135 White.

It’s a du-al loader. It’s a 2-135

 

[rrlund]

It’s a du-al loader. It’s a 2-135

If it's like my Dunham Du-al, you need to bolt a bracket to the front of the frame. The 1755 has a flat front with bolt holes. The 2-135 has a curved cast front with no holes. You'd have to figure out how to bolt something on there and that might bring the whole thing so far forward that your rear mounts wouldn't line up. Anything's possible with a torch and welder I suppose, but I think you'd need a whole bunch of heavy flat plate to make a whole frame around the entire front of the tractor.

 

[farmer52]

Learn to spell - COCKSHUTT! Just sayin'

 

[Bison2010]

If it's like my Dunham Du-al, you need to bolt a bracket to the front of the frame. The 1755 has a flat front with bolt holes. The 2-135 has a curved cast front with no holes. You'd have to figure out how to bolt something on there and that might bring the whole thing so far forward that your rear mounts wouldn't line up. Anything's possible with a torch and welder I suppose, but I think you'd need a whole bunch of heavy flat plate to make a whole frame around the entire front of the tractor.

OK, thanks it sounds like it could be a bit of a project