(800) 853-2651
SHOP NOW

Recent content by Bob Tedford

Yesterday's Tractor Forums
  1. R

    What does the square shaft on the governor do?

    I've got the governor ready to reinstall on the Model G and was studying the square shaft on the governor that connects to the shaft from the crank case. You know the one that has the square cuplelng that breaks once in while? What does it do? it looks like it might be an air pump? I can't say...
  2. A

    My youngest calf

    he was born early August. The red one.
  3. B

    farmall 650 diesel injector orifice?

    need a orifice to complete injector some one had it apart and must have lost it or missplaced it to complete it. from my books it is the same as a 400d but the used three different sizes and need the biggest one or one of the other two to drill out will buy complete injectors or part if any one...
  4. D

    SMD Thompson Live pump - leaking

    I had a bad leak between my pump body and the manifold underneath, caused by old flat o-rings. I installed new greased O-rings and it is substantially better, but still leaks maybe 3 drips a minute from between the pump housing and the manifold underneath. Are there any other tricks to seal...
  5. T

    NI 402

    Neighbor ask me to help him put a new belt on his NI 402 rake, Can anyone give me a walk thru on how to install the belt. I researched the archives but none seemed to address the procedure.I'm just helping him this is a freebie Thanks gobble
  6. K

    Cockshutt 30 distributor

    The rotor has play in the distributor and I think I should replace the bearings. I have a intermittent miss at idle. Is there anything special I need to look for when doing this? It is a prestolite.
  7. R

    Need a plunger for a Ford 542 baler

    Any help in finding one in or around Tennessee would be greatly appreciated.
  8. E

    upcoming Usap pulls

    just wanted to pass on some info. the pull scheduled for july 19 at the Warrick county fair has been cancelled. seems the fair is not having ANY pulls this year and are having a concert by andrea wirth(has anybody ever heard of her?). Also to clarify. the pull at meade county...
  9. D

    case voc

    Hi, Am loosing the Case vao I"ve used since a kid to family member in estate settlement. Guy a county over has a case VOC listed. Talked to him on phone and sounds like VOA but exhaust goes up like vac instead of under floorboard. It has hydralics and belt drum and sounds like nice rig and...
  10. B

    1070 case gear ratios

    I have a new to me case 1070, does anyone have the miles per hour = gear selection chart, going to plant with it and need to know what comb. will get me approx 4 miles per hour , many thanks Bill Thurman
  11. P

    5000 ford

    The three point hitch on my 5000 ford has a constent jump to it is there a way to fix this
  12. Kow Farmer

    tractor cab heater questions

    Hello everyone, I need some advice as to the way my cab heater is heating improperly. I have a Year-A-Round aftermarket cab on my Oliver 1850 gas tractor. I flushed the heater core that is in the cab ceiling with a water hose. Lots of disgusting black water came out. I hooked up the water heater...
  13. H

    MODEL 509 CASE POWER UNIT

    I have a model 509 case power unit . When I try to order a gasket set etc and give the parts dealer the model and serial #'s they have a lot of trouble matching up the numbers to the right parts. Does anyone out there have any suggestions to simplify this procces. Do I need to ask for a certain...
  14. R

    3/4 air impact wrench

    i have a couple of 3/4 air impact guns that quite working so i tore into one of them cleaned it all up inside nothing really looked worn out.but there is one oring about maybe 1 inch in diameter i didnt replace and it still wont run the air just bypasses out the exhaust you suppose the oring is...
  15. L

    Bosch vs. IHC Magnetos

    Our '45 M came with a MJC4C-302 American Bosch magneto. Sometime in the 50s it was converted to battery ignition and the mag has sat on a shelf ever since. I have a '49 H with an H-4 IHC mag on it, but it is not working very well. Can I put the Bosch on that H? Furthermore, can anyone tell...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top