Recent content by BOH

  1. B

    D14 tach

    Thanks for the info Istra !!. Will definitely give him a call.
  2. B

    D14 tach

    Does anyone rebuild worn out tachs? I replaced the old one with an aftermarket replacement, but just ain't the same. Wouldn't mind paying to get the original rebuilt.
  3. B

    Things to look for buying a Mc-Deering 10-20

    just get her up to a compression stroke and give her a quick snap. Make sure the crank has plenty of lube where it connects. Keep your thumb on top of the crank. They are bullet-proof. You Tube has a great video of an old guy starting one.
  4. B

    Wd45 value

    They have a tendency to jump out of 3rd gear. That is a bit of a project. Just take it down a hill, if it is gonna jump out of gear it will do it then.
  5. B

    -14 here

    -26 NW Wisconsin
  6. B

    Revisit "no power to points"

    Awhile back I was asking for a friend what may be the problem he had not getting power to the points on his 2N. It finally warmed up enough for him to get back to it. It turns out someone did in fact use a piece of wire instead of the proper pin to hold the points in place and somehow it was...
  7. B

    no power to points

    Yep that's it. He says his is not that neat and clean though😏.
  8. B

    no power to points

    Thanks for the reply. Any idea what the trouble could be? I am not familiar with this vintage at all. Thx
  9. B

    no power to points

    I have a buddy that acquired a 2n. He has power to the coil, but nothing to the points. Should the wire running from the coil to the distributor be some sort of a resister wire? It looks like somebody did play with the wiring! Thanks in advance
  10. B

    Slack noise in receiver hitch

    I have a Ford Explorer that drove me nuts when pulling a trailer especially an empty one. The cast plate with a u bolt did the trick for me. Mine is made by Reese, bought it at Advance Auto Supply. Only takes a minute to install, keep the 9/16 wrench right with the hitch. Happy camper now :wink:
  11. B

    Tonight’s funny

    If texting continues, that will be top of the line in the next few years. :?
  12. B

    which plugs should I use

    Well i re-gaped the plugs to .025. She is running quite a bit better. The plugs haven't been in long enough to get a good color yet. Thinking more about it the old plugs were kind of black, but not too bad. I probably am not working her hard enough for the B6S. I think when the day is done I...
  13. B

    which plugs should I use

    Thanks guys. Yep I always check the gap. I have the original owners manual (it is a 1957) and it says .028-.033. I set them to .030 prolly try closing them to .025 first, then I guess I'll start down the list and hope for the best. I didn't notice any comments on going hotter or colder, so will...
  14. B

    which plugs should I use

    I changed the plugs in my D-14. She had Champion J8C. The new set of the same had 2 new plugs that gave me trouble. No matter where I put them, they would not fire all the time. I gave up and installed NGK B6S. Ran like a new one...until I hooked up the brush hog. It still runs great until I get...
  15. B

    Welding rod

    I find 7014 is a more versatile rod...not as finicky, especially in humid weather.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top