Recent content by Brad500

  1. B

    TO 30

    Will be better able to see once the oil is drained. any tricks for washing down with diesel? Was going to use a pump up sprayer to get in all the hard to reach parts. Also going to take off the left inspection plate for a better view. Does the pto handle come off with the plate?
  2. B

    TO 30

    Got the right hand cover off the oil inside is a milky orange yellow color. I could move the forks and the valve doesn't appear to be stuck. My next step is to drain the oil and clean out the housing as best i can with kerosene then refill and see if that helps. Any other suggestions would be...
  3. B

    TO 30

    Thanks so much I will dig into this weekend hopefully it will be a simple fix.
  4. B

    TO 30

  5. B

    TO 30

    I finally got the engine running on the 1953 TO 30, however the power lift will not respond. The pto runs fine. I have not changed the oil in the rear end yet. What steps should I take to fix the problem? The tractor set out in the weather for several years. The oil in the rear appears ok...
  6. B

    TSX 805 Carburetor

    Thanks I checked the venturi size and they are not the same. I think I will purchase a rebuilt one. Still have a lot to do before I get to the point off putting everything back together. Waiting on gas tank and radiator to be cleaned and restored. This has been an interesting project for sure.
  7. B

    TSX 805 Carburetor

    I had taken the carburetor off and after giving it a good cleaning found the the part number. TSX 805 and then 55 also stamped into the body. Not able to associate that model number with a Ferguson tractor I looked it up on Carbs Unlimited and found this model was used on a John Deere 55...
  8. B

    Intake and exhaust manifold

    Yes that’s it took off the carb and it appears it just one solid piece maybe left over from manufacturers. Just appears to be two pieced
  9. B

    Intake and exhaust manifold

    No right below the vacuum plug. The carburetor is below that and attached to the the intake part of the manifold. Just above the flange where the carburetor is attached is the separation You can see it in the photo.
  10. B

    Intake and exhaust manifold

    It is right below the plug on the intake. I will try to take a better photo tonight.
  11. B

    Intake and exhaust manifold

    I was beginning to take off the carburetor last night but noticed where the carburetor attaches to the intake there appears to be a separation between the intake pipe and where the carburetor attaches. It doesn't look like it is cracked but very clean as if someone sawed through it. Is it...
  12. B

    TO 30

    Thanks for your reply. I did take off the air cleaner and it was extremely dirty. The Tractor had set it a field for several years. My relative got dismayed with it because it would run hot and the gas tank was corroded and gas would not flow correctly. I was able to turn the front crankshaft...
  13. B

    TO 30

    Also what would cause the oil to smell oh gas? I haven’t drained the oil yet but the oil on the dipstick smells like gasoline
  14. B

    TO 30

    I have what I believe to be a TO 30 Ferguson manufactured in 1953 according to the serial number. The tractor has a red hood an a decal on both sides "Massey Ferguson 35" I was given this tractor by a relative. Due to the fact it was painted red and silver and the decals are wrong I assume...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top