Recent content by Bradford

  1. B

    826 MCV behavior

    One more reply. I don't think it is the pilot valve unless it has a passage into the clutch housing because there is no oil from the top of the tractor just the bottom of the clutch housing and the clutch inspection window weeps a little. I hope the oil doesn't saturate the clutch and ruin it...
  2. B

    826 MCV behavior

    Rebuilding the MCV next though is what I meant to say. Curtis
  3. B

    826 MCV behavior

    Thanks Owen, Now that I think about it, i was shredding yesterday and it didn't freewheel going downhill when it used to. I'll pull the T/A back and see what happens next time I use the tractor. Can't see changing the T/A at this point because it runs so good and steers like a dream. I will...
  4. B

    826 MCV behavior

    I've had my 826 for about two years and the mcv valve was never right. I would get pressure for the brakes and circulating through the tranny but the steering was getting nothing. No leaks anywhere. All of a sudden the steering is getting pressure, I can turn it with one finger, but it is...
  5. B

    826 oil leak?

    I have an 826, it runs fine but after an hour or so oil is seeping out around that small plate on the clutch bell housing. It is not leaking out the bottom of the clutch bell housing just seeping pretty good from aroung the examination window where the plate is bolted on. I can"t tell if it is...
  6. B

    Battery problem.

    sorry, was busy. all are 12 volts. 826 international. my very basic charger has a meter that goes from 0 to 100 percent charged as it charges a battery. this battery just makes the needle go haywire and pegs the needle way away from 0 percent charged like the battery has a short in it or...
  7. B

    Battery problem.

    I bought a new battery and there's a problem. I had been wiring two old batteries pos to pos and neg to neg but they finally got too old. Well i tried my new battery by itself but there just wasn't much juice. When i tried to wire it it with the better of my two old batteries there was a...
  8. B

    826 draining coolant.

    Just wondering if there is a coolant drain plug on the block on a 826 German Diesel. I can't find one so I disconnected the lower radiator hose from the radiator. Does all the coolant drain out that way? Thanks for everyone's help.
  9. B

    826 stops then goes

    I have been leaving it forward. And it is about a gallon low of hyd fluid. The left brake is leaking. So I guess I am gonna rebuild the brakes, and add about 4 gallons of fluid and hope I get another few years of use before I split it apart. Thanks.
  10. B

    826 stops then goes

    I have a 826 runs great. Was bushhogging the other day and twice it stopped like I pushed the clutch in. I did press the clutch in then let it out and it was fine. I cut for 4-5 hours with no problem otherwise. The T/A is out it does nothing and it freewheels going down a hill. The only...
  11. B

    826 sticky question.

    well, i guess i've read too much about it but i heard that just a little anti-freeze in the oil will ruin the oil. really, my question was about how cold it needs to be and for how long to freeze a block. i see now i'm just lazy not to drain it, which i'll do now in the winter months. and keep...
  12. B

    826 sticky question.

    This is a weekend tractor. or a once a month tractor because i got too much else going on. And it's kinda rough but it runs great. here's my problem. I am guessing the cylinder sleeves are leaking but only in the winter. in the summer they don't leak. i just open the oil plug and let about...
  13. B

    826 bad starter?

    Just saw a post about how to test with battery cables. Problem is I didn't have any today so i'll try it next week. But any other pointers would be a big help. Thanks.
  14. B

    826 bad starter?

    My 826 was spinning just fine up with an old Continental battery. Uses one 12 volt. I put in my pickups battery but it still just turns real slow. Not near enough to start it. All the cables are good. Does a starter motor on these go out like this? There's a new solenoid but I am guessing...
  15. B

    826 extra fuel on starting

    I don"t think my fuel pump gives the extra fuel when starting. I"ve taken the kill cable off and tried to get it to race the motor when pulling the kill level back when running as I learned here on the forum. But it just kinda stalls no matter where a pull it to. Is this an easy fix or a...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top