(800) 853-2651
SHOP NOW

Recent content by Brady Eldridge

Yesterday's Tractor Forums
  1. B

    Carburetor TSX-245 Question

    I've got a couple of different TSX-245 carburetors and the one that I'm rebuilding has a different size air inlet than the rest of them and it appears that the wrong choke baffle is installed because there is approximately an 1/8 of an inch around the whole thing when it is centered. Does anyone...
  2. B

    Installing John Deere 40 Radiator Mounts

    Thanks. I"ll give it a try.
  3. B

    Installing John Deere 40 Radiator Mounts

    Does anyone know what"s the best way to install the rivets for the radiator mounting pads. Do I need a special tool to install the rivets. Any help would be appreciated.
  4. B

    John Deere 40 Clutch replacement

    Thanks for all the information
  5. B

    John Deere 40T tires sizes

    Thanks mike. Do you know what was standard on the rear. 34" or 28". Thanks again.
  6. B

    John Deere 40T tires sizes

    What size do you have on your mt
  7. B

    John Deere 40T tires sizes

    Thanks for the posts guys. I have the parts manual and operators manual, but it only states what was available and doesn't say what was standard. So does everyone agree that 11.2x34 on the rear and 5.00-15 on the front is the way to go. Thanks
  8. B

    John Deere 40T tires sizes

    Does anyone know what the most common combination of front and rear tires were for the John Deere 40t tractors. I have no idea what they are suppposed to be. I want the tractor to look original. Thanks
  9. B

    John Deere 40 distributor rebuild

    Ron8 are you a supplier. If so where can I get more information. thanks
  10. B

    John Deere 40 distributor rebuild

    I am rebuilding a tractor that my grandpa had and basically it has been setting up for about 15 years. The engine still will turn over when I pull with the clutch engaged. My next step is to try to get it to fire, but it has been setting up with the distributor cap off. Pretty much all of it...
  11. B

    John Deere 40 12volt conversion

    Does anyone know if the John Deere 40 series is a 12 volt system or a 6 volt. If it is a 6 volt then what do I need to convert it. Thanks
  12. B

    John Deere 40 Model Identification

    Hey do you know where a good site is to find out about the different implements that were used for the MT. Were they specifically made for the MT or was it like now where any 3 point hitch implement will hook up to any 3 point hitch tractor. Thanks
  13. B

    John Deere 40 Model Identification

    Thanks alot. The tractor is at my grandfathers so I will run by there and take some pics as soon as possible.
  14. B

    John Deere 40 Model Identification

    Thanks.Why on the rear wheels on this tractor does it have a shaft coming through the center of the wheel that sticks out a little over a foot. what was the purpose of this.
  15. B

    John Deere 40 Model Identification

    Thanks for all the help guys. It looks like I may have a tractor that is pieced together. Does anyone know if one tractor is better or more preferred than the other between the 40 and the M. Thanks
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top